Search results
Results from the WOW.Com Content Network
10 Gigabit Ethernet is a version of Ethernet with a nominal data rate of 10 Gbit/s, ten times as fast as Gigabit Ethernet. The first 10 Gigabit Ethernet standard, IEEE Std 802.3ae-2002, was published in 2002. Subsequent standards encompass media types for single-mode fiber (long haul), multi-mode fiber (up to 400 m), copper backplane (up to 1 m ...
Where channels use line codes (such as Ethernet, Serial ATA, and PCI Express), quoted rates are for the decoded signal. The figures below are simplex data rates, which may conflict with the duplex rates vendors sometimes use in promotional materials.
Supermicro AOC-SGP-I2 dual-port Gigabit Ethernet NIC, a PCI Express ×4 card. 1000BASE-T (also known as IEEE 802.3ab) is a standard for Gigabit Ethernet over twisted-pair wiring. Each 1000BASE-T network segment is recommended to be a maximum length of 100 meters (330 feet), [5] [a] and must use Category 5 cable or better (including Cat 5e and ...
A standardized variant of 10 Gigabit Ethernet, called WAN PHY, is designed to inter-operate with OC-192 transport equipment while the common version of 10 Gigabit Ethernet is called LAN PHY (which is not compatible with OC-192 transport equipment in its native form). The naming is somewhat misleading, because both variants can be used on a wide ...
IEEE 802.3 is a working group and a collection of standards defining the physical layer and data link layer's media access control (MAC) of wired Ethernet.The standards are produced by the working group of the Institute of Electrical and Electronics Engineers (IEEE).
The physical coding sublayer (PCS) is a networking protocol sublayer in the Fast Ethernet, Gigabit Ethernet, and 10 Gigabit Ethernet standards. It resides at the top of the physical layer (PHY), and provides an interface between the physical medium attachment (PMA) sublayer and the media-independent interface (MII).
10 Gigabit Ethernet (abbreviated 10GE, 10GbE, or 10 GigE) is a group of computer networking technologies for transmitting Ethernet frames at a rate of 10 gigabits per second. It was first defined by the IEEE 802.3ae-2002 standard.
On April 6, 2020, 25 Gigabit Ethernet Consortium has rebranded to Ethernet Technology Consortium, and it announces 800 Gigabit Ethernet (GbE) specification. [ 10 ] On June 4, 2020, the IEEE approved IEEE 802.3ca which allows for symmetric or asymmetric operation with downstream speeds of 25 or 50 Gbit/s, and upstream speeds of 10, 25, or 50 ...