Search results
Results from the WOW.Com Content Network
Loopback (also written loop-back) is the routing of electronic signals or digital data streams back to their source without intentional processing or modification. It is primarily a means of testing the communications infrastructure. Loopback can take the form of communication channels with only one communication endpoint.
IEEE 802.1ag is an amendment to the IEEE 802.1Q networking standard which introduces Connectivity Fault Management (CFM).This defines protocols and practices for the operations, administration, and maintenance (OAM) of paths through 802.1 bridges and local area networks (LANs).
Being network devices supported entirely in software, they differ from ordinary network devices which are backed by physical network adapters. The Universal TUN/TAP Driver originated in 2000 as a merger of the corresponding drivers in Solaris, Linux and BSD. [1] The driver continues to be maintained as part of the Linux [2] and FreeBSD [3] [4 ...
The address 127.0.0.1 is the standard address for IPv4 loopback traffic; the rest are not supported by all operating systems. However, they can be used to set up multiple server applications on the host, all listening on the same port number. In the IPv6 addressing architecture [3] there is only a single address assigned for loopback: ::1. The ...
Link-local addresses may be assigned manually by an administrator or by automatic operating system procedures. In Internet Protocol (IP) networks, they are assigned most often using stateless address autoconfiguration, a process that often uses a stochastic process to select the value of link-local addresses, assigning a pseudo-random address that is different for each session.
Ethernet Configuration Testing Protocol is a diagnostic protocol included in the Xerox Ethernet II specification. [1] Functionality of the protocol is similar to that offered by ping but it operates at the data link layer as opposed to the network layer. Ethernet Configuration Testing Protocol was implemented on DEC hosts and Cisco routers. [2]
Ethernet II framing considered these octets to represent EtherType while the original IEEE 802.3 framing considered these octets to represent the size of the payload in bytes. In order to allow Ethernet II and IEEE 802.3 framing to be used on the same Ethernet segment, a unifying standard, IEEE 802.3x-1997, was introduced that required that ...
For example, user A and user B both try to access a quiet link at the same time. Since they detect a collision, user A waits for a random time between 0 and 1 time units and so does user B. Let's say user A chooses a lower back-off time. User A then begins to use the link and B allows it to finish sending its frame. If user A still has more to ...