Search results
Results from the WOW.Com Content Network
The rocket was fired from two rails; aiming was simple, behind a shield the layer on the right hand side pushed the apparatus in the direction of the target using a crude sighting device and the layer on the left locked the launcher before the rocket was fired using electrical ignition. A test battery was set up at Aberporth and other rocket ...
Most rockets need to be supported and held down for a few seconds after ignition while the engines build up to full thrust. The vehicle is commonly held on the pad by hold-down arms or explosive bolts, which are triggered when the vehicle is stable and ready to fly, at which point all umbilical connections with the pad are released. [2]
A pad abort occurred after ignition of the shuttle's main engines but prior to liftoff. An abort during ascent that would result in the orbiter returning to a runway or to an orbit lower than planned was called an "intact abort", while an abort in which the orbiter would be unable to reach a runway, or any abort involving the failure of more ...
A gravity turn is commonly used with rocket powered vehicles that launch vertically, like the Space Shuttle. The rocket begins by flying straight up, gaining both vertical speed and altitude. During this portion of the launch, gravity acts directly against the thrust of the rocket, lowering its vertical acceleration.
Space launch involves liftoff, when a rocket or other space launch vehicle leaves the ground, floating ship or midair aircraft at the start of a flight. Liftoff is of two main types: rocket launch (the current conventional method), and non-rocket spacelaunch (where other forms of propulsion are employed, including airbreathing jet engines).
RS-68 being tested at NASA's Stennis Space Center Viking 5C rocket engine used on Ariane 1 through Ariane 4. A rocket engine is a reaction engine, producing thrust in accordance with Newton's third law by ejecting reaction mass rearward, usually a high-speed jet of high-temperature gas produced by the combustion of rocket propellants stored inside the rocket.
Rutherford is a liquid-propellant rocket engine designed by aerospace company Rocket Lab [8] and manufactured in Long Beach, California. [9] The engine is used on the company's own rocket, Electron. It uses LOX (liquid oxygen) and RP-1 (refined kerosene) as its propellants and is the first flight-ready engine to use the electric-pump-fed cycle.
The rocket is launched using liquid hydrogen and liquid oxygen cryogenic propellants. Rocket propellant is used as reaction mass ejected from a rocket engine to produce thrust . The energy required can either come from the propellants themselves, as with a chemical rocket , or from an external source, as with ion engines .