Ad
related to: umi g body rear coilover kit instructions book 1 10
Search results
Results from the WOW.Com Content Network
Coilovers are used in double wishbone suspension systems, [2] and are often a component of MacPherson struts. [3] Two of the main types of coilovers are full coilovers and slip-on coilovers. Full coilovers are matched up with a shock absorber from the factory, while with slip-on coilovers, the dampers and springs are bought separately and then ...
4] The complete rear suspension assembly is carried in a steel crossbeam cradle (shown ghosted in the diagram below), which is attached to the vehicle body via four rubber vee-blocks and also carries the differential (blue) and inboard brakes (red). The rear wheels are located transversely by top links and wheel carriers (green) and lower links ...
The General Motors G platform (also called G-body) was an automobile platform designation used for mid-sized rear-wheel drive cars. It made its first appearance from the 1969 to 1972 model years, adapted from GM's A-body , and reappeared from 1982 to 1988.
The front of the H attaches to the body via rubber bushings, and the rear of the H carries each stub-axle assembly, on each side of the car. The cross beam of the H holds the two trailing arms together, and provides the roll stiffness of the suspension, by twisting as the two trailing arms move vertically, relative to each other.
To compensate for the uneven (35/65) weight distribution caused by the rear-mounted engine, DeLorean used rear wheels with a diameter slightly greater than the front wheels. Before that was the rear-engined Škoda's from Škoda 1000MB (produced from 1964) to Škoda 130/135/136 (produced until 1990) or the Polski Fiat 126p (produced until ...
The General Motors G platform (also called G-body) designation was used for three different automobile platforms. 1969–1972 GM G platform (RWD) 1982–1988 GM G platform (RWD) 1995–2011 GM G platform (FWD)
Camber changes due to wheel travel, body roll and suspension system deflection or compliance. In general, a tire wears and brakes best at -1 to -2° of camber from vertical. Depending on the tire and the road surface, it may hold the road best at a slightly different angle. Small changes in camber, front and rear, can be used to tune handling.
Identification between the two can be made by examining the hub: the protrusion of the hub through the center of the wheel denotes the preferred 10.5-inch full-floating rear axle. While the 9.5-inch rear end exhibits its own durability, it is generally considered less favorable for high-torque applications.
Ad
related to: umi g body rear coilover kit instructions book 1 10