Ads
related to: moen faucet dripping from spout back on water pump replacement
Search results
Results from the WOW.Com Content Network
The most common plumbing fixtures are: Bathtubs; Bidets; Channel drains; Drinking fountains; Showers; Sinks; Tap (connections for water hoses) . Tapware - an industry term for that sub-category of plumbing fixtures consisting of tap valves, also called water taps (British English) or faucets (American English), and their accessories, such as water spouts and shower heads.
Faucet is the most common term in the US, similar in use to "tap" in British English, e.g. "water faucet" (although the term "tap" is also used in the US). Spigot is used by professionals in the trade (such as plumbers), and typically refers to an outdoor fixture.
Alfred M. Moen (27 December 1916 – 17 April 2001) was an American inventor and founder of Moen Incorporated.He invented the single-handed mixing faucet.In 1959 Fortune magazine listed the Moen "one-handle mixing faucet", along with inventions such as Henry Ford's Model T and Benjamin Franklin's Franklin stove, as one of the top 100 best-designed mass-produced products, the result of a survey ...
Most Moen kitchen, washbasin, and bathtub/shower faucets are of the single-handle design, and almost all have used the same basic water-controlling cartridge from the 1960s until 2010. Known as the Moen 1225, it is a plastic (older versions were brass) cylinder approximately 4 inches long by 3/4 inches in diameter.
In these situations the unwanted flow is not actually the result of a siphon but suction due to reduced pressure on the water supply side. Should the pressure within the water supply system fall, the external water may be returned by back pressure into the drinking water system through the faucet.
Backflow occurs for one of two reasons, either back pressure or back siphonage. [1] Back pressure is the result of a higher pressure in the system than in its supply, i.e. the system pressure has been increased by some means. This may occur in unvented heating systems, where thermal expansion increases the pressure.
A chain pump is a type of water pump that uses a chain to move water from one place to another. It works on the principle of a continuous loop of chain moving through a series of sprockets, with attached buckets that lift water as the chain passes over the top sprocket and discharge it as the chain reaches the bottom. [12]
Back pressure is the term used for the hydraulic pressure required to create a flow through a chromatography column in high-performance liquid chromatography, the term deriving from the fact that it is generated by the resistance of the column, and exerts its influence backwards on the pump that must supply the flow. Back-pressure is a useful ...
Ads
related to: moen faucet dripping from spout back on water pump replacement