Search results
Results from the WOW.Com Content Network
For example, if the static compression ratio is 10:1, and the dynamic compression ratio is 7.5:1, a useful value for cylinder pressure would be 7.5 1.3 × atmospheric pressure, or 13.7 bar (relative to atmospheric pressure). The two corrections for dynamic compression ratio affect cylinder pressure in opposite directions, but not in equal strength.
In aeronautical engineering, overall pressure ratio, or overall compression ratio, is the amount of times the pressure increases due to ram compression and the work done by the compressor stages. The compressor pressure ratio is the ratio of the stagnation pressures at the front and rear of the compressor of a gas turbine .
Variable compression ratio (VCR) is a technology to adjust the compression ratio of an internal combustion engine while the engine is in operation. This is done to increase fuel efficiency while under varying loads. Variable compression engines allow the volume above the piston at top dead centre to be changed. Higher loads require lower ratios ...
A compression artifact (or artefact) is a noticeable distortion of media (including images, audio, and video) caused by the application of lossy compression. Lossy data compression involves discarding some of the media's data so that it becomes small enough to be stored within the desired disk space or transmitted ( streamed ) within the ...
There are several differences, but the main one in practice is that compression ratio is applied to piston engines, pressure ratio to gas turbines. Compression ratio is the cause of the compression, pressure ratio is the result of this compression and increase in pressure. Compression ratio can be calculated easily from the engine's geometry.
The engine pressure ratio (EPR) is the total pressure ratio across a jet engine, measured as the ratio of the total pressure at the exit of the propelling nozzle divided by the total pressure at the entry to the compressor. [1] Jet engines use either EPR or compressor/fan RPM as an indicator of thrust. [2]
A high compression ratio is used in the auxiliary combustion chamber. A moderate compression ratio is used in the main combustion chamber wherein a homogeneous air-fuel mixture is compressed / heated near, yet below, the auto-ignition threshold.
The LFV is a direct-injection 1.5 L turbocharged SGE variant, with a 74 mm × 86.6 mm (2.91 in × 3.41 in) bore and stroke for a total capacity of 1,490 cc (1.5 L). Compression ratio is 10.0:1 and the engine can run on regular unleaded-grade gasoline. Maximum engine speed is 6500 rpm. Automatic Start-Stop is available with this engine. Assembly ...