Search results
Results from the WOW.Com Content Network
For acid–base reactions, the equivalent weight of an acid or base is the mass which supplies or reacts with one mole of hydrogen cations (H +). For redox reactions, the equivalent weight of each reactant supplies or reacts with one mole of electrons (e −) in a redox reaction. [3]
The solution has 1 mole or 1 equiv Na +, 1 mole or 2 equiv Ca 2+, and 3 mole or 3 equiv Cl −. An earlier definition, used especially for chemical elements , holds that an equivalent is the amount of a substance that will react with 1 g (0.035 oz) of hydrogen , 8 g (0.28 oz) of oxygen , or 35.5 g (1.25 oz) of chlorine —or that will displace ...
Thermodynamic data is usually presented as a table or chart of function values for one mole of a substance (or in the case of the steam tables, one kg). A thermodynamic datafile is a set of equation parameters from which the numerical data values can be calculated.
For example, sulfuric acid (H 2 SO 4) is a diprotic acid. Since only 0.5 mol of H 2 SO 4 are needed to neutralize 1 mol of OH −, the equivalence factor is: f eq (H 2 SO 4) = 0.5. If the concentration of a sulfuric acid solution is c(H 2 SO 4) = 1 mol/L, then its normality is 2 N. It can also be called a "2 normal" solution.
The solvent (e.g. water) is omitted from the defining expression on the assumption that its concentration is very much greater than the concentration of dissolved acid, [H 2 O] ≫ T A. The equation for mass-balance in hydrogen ions can then be written as T H = [H +] + [A −][H +]/K a − K w / [H +]
It can be prepared by treating a potassium-containing base such as potassium hydroxide or potassium carbonate with acetic acid: CH 3 COOH + KOH → CH 3 COOK + H 2 O. This sort of reaction is known as an acid-base neutralization reaction. At saturation, the sesquihydrate in water solution (CH 3 COOK·1½H 2 O) begins to form semihydrate at 41.3 ...
The hydroxyl value can be calculated using the following equation. Note that a chemical substance may also have a measurable acid value affecting the measured endpoint of the titration. The acid value ( AV ) of the substance, determined in a separate experiment, enters into this equation as a correction factor in the calculation of the hydroxyl ...
3 in solution represents 1 molar equivalent, while 1 mole of CO 2− 3 is 2 molar equivalents because twice as many H + ions would be necessary to balance the charge. The total charge of a solution always equals zero. [8] This leads to a parallel definition of alkalinity that is based upon the charge balance of ions in a solution.