enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of scale model sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_scale_model_sizes

   1:87.1: 3.5 mm: Model railways (HO/h0) Exact HO scale (half O of 7 mm = 1 foot) 1:87: 3.503 mm: Model railways (HO/h0) Civilian and military vehicles. Often used to describe HO scale. Original nominal 25 mm figure scale; though a 6-foot human in 1:87 is closer to 21 mm. 1:82: 3.717 mm

3. Scale ruler - Wikipedia

   en.wikipedia.org/wiki/Scale_ruler

   A scale ruler is a tool for measuring lengths and transferring measurements at a fixed ratio of length; two common examples are an architect's scale and engineer's scale.In scientific and engineering terminology, a device to measure linear distance and create proportional linear measurements is called a scale.

4. List of rail transport modelling scale standards - Wikipedia

   en.wikipedia.org/wiki/List_of_rail_transport...

   Using 32 mm (1.26 in) - 0 gauge - track, there is an extensive range of 16 mm to the foot scale [1:19] live-steam and other types of locomotives, rolling stock and accessories. Many of these models are dual gauge, and can be converted to run on 45 mm ( 1.772 in ) track ( gauge 1 ), and radio control is common.

5. National pipe thread - Wikipedia

   en.wikipedia.org/wiki/National_pipe_thread

   The taper rate for all NPT threads is 1 inch of diameter in 16 inches of length (3 ⁄ 4 inch per foot or 62.5 millimeters per meter) measured by the change of diameter (of the pipe thread) over distance of thread.

6. File:Mm to 1 inch fraction ruler.svg - Wikipedia

   en.wikipedia.org/wiki/File:Mm_to_1_inch_fraction...

   English: a ruler from 0 to 1 inch (in.) in 1/32 inch divisions below the line and 1/2 millimetre (mm) divisions above the line to give a visual representation of the approximations. Principally designed to help visually determine if a metric or imperial drill bit will suffice.

7. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   The major minus pitch also works for inch-based threads, but you must first determine the pitch by looking at the number of treads per inch (TPI; for example, 1 ⁄ 20 = 0.050 and 1 ⁄ 13 ≈ 0.077), and your result will only land near a tap drill size (not directly on one).

8. Hole punch - Wikipedia

   en.wikipedia.org/wiki/Hole_punch

   The holes are positioned symmetrically, with the centers 4 + 1 ⁄ 4 inches (108 mm) apart. It requires paper formats that are at least 9 + 1 ⁄ 2 inches (241 mm) high. There is a variant for half-letter size pages (8 + 1 ⁄ 2 by 5 + 1 ⁄ 2 inches or 220 mm × 140 mm), whose three holes are 2 + 3 ⁄ 4 inches (70 mm) apart.

9. Millimetre - Wikipedia

   en.wikipedia.org/wiki/Millimetre

   Different lengths as in respect to the electromagnetic spectrum, measured by the metre and its derived scales.The microwave is between 1 meter to 1 millimeter.. The millimetre (international spelling; SI unit symbol mm) or millimeter (American spelling) is a unit of length in the International System of Units (SI), equal to one thousandth of a metre, which is the SI base unit of length.