Search results
Results from the WOW.Com Content Network
Water pressure motors, having a piston and cylinder with inlet and outlet valves: their action is that analogous of a steam- or gas-engine with water as the working fluid – see water engine; Water wheels [2] Turbines, deriving their energy from high velocity jet of jets (the impulse machine), or from water supplied under pressure and passing ...
The pump was used in dry dock operations and also for experimental purposes. It was designed as a 2-stroke engine to operate in a range of head from 20 to 150 ft (6 to 46 m). The engine was installed in a 18 ft 6 (5.6 m) diameter and 50 ft (15.25 m) deep steel caisson, about 40 ft below the Delaware river.
The following diagram shows the relation between the angle of the crankshaft and the delivery rate of a single-acting and double-acting pump. The line shows the average delivery rate of the pump. These fluctuations in pressure and delivery can cause undesired effects such as water hammer and thus are generally mitigated by the installation of ...
A pump-jet works by having an intake (usually at the bottom of the hull) that allows water to pass underneath the vessel into the engines. Water enters the pump through this inlet. The pump can be of a centrifugal design for high speeds, or an axial flow pump for low to medium speeds. The water pressure inside the inlet is increased by the pump ...
A Watt engine: showing entry of steam and water. A beam engine is a type of steam engine where a pivoted overhead beam is used to apply the force from a vertical piston to a vertical connecting rod. This configuration, with the engine directly driving a pump, was first used by Thomas Newcomen around 1705 to remove water from mines in Cornwall.
A gerotor / dʒ ə ˈ r oʊ t ə r / is a positive displacement pump. The name gerotor is derived from "generated rotor." A gerotor unit consists of an inner and an outer rotor. The inner rotor has n teeth, while the outer rotor has n + 1 teeth, with n defined as a natural number greater than or equal to 2. The axis of the inner rotor is offset ...
An eccentric rotary vane pump Another eccentric rotary-vane pump design. Note that modern pumps have an area contact between rotor and stator (and not a line contact). 1. pump housing 2. rotor 3. vanes 4. spring. A rotary vane pump is a type of positive-displacement pump that consists of vanes mounted to a rotor that rotates inside a cavity. In ...
Part of an axial turbopump designed and built for the M-1 rocket engine. A turbopump is a propellant pump with two main components: a rotodynamic pump and a driving gas turbine, usually both mounted on the same shaft, or sometimes geared together. They were initially developed in Germany in the early 1940s.