enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Servo control - Wikipedia

   en.wikipedia.org/wiki/Servo_control

   Servo and receiver connections A diagram showing typical PWM timing for a servomotor. Servo control is a method of controlling many types of RC/hobbyist servos by sending the servo a PWM (pulse-width modulation) signal, a series of repeating pulses of variable width where either the width of the pulse (most common modern hobby servos) or the duty cycle of a pulse train (less common today ...

3. List of Arduino boards and compatible systems - Wikipedia

   en.wikipedia.org/wiki/List_of_Arduino_boards_and...

   Arduino Uno compatible, D13 pin isolated with a MOSFET of which can also be used as an input. KitTen [126] ATmega328P Freetronics Includes both 3.3 V and 5 V regulators for shields, D13 pin isolated with a MOSFET of which can also be used as an input. Can be connect to Arduino using CAT5 cable. [127] EtherDue [128] ATSAM3X8E [16] Freetronics

4. Servomotor - Wikipedia

   en.wikipedia.org/wiki/Servomotor

   A servomotor (or servo motor or simply servo) [1] is a rotary or linear actuator that allows for precise control of angular or linear position, velocity, and acceleration in a mechanical system. [ 1 ] [ 2 ] It constitutes part of a servomechanism , and consists of a suitable motor coupled to a sensor for position feedback and a controller ...

5. Servomechanism - Wikipedia

   en.wikipedia.org/wiki/Servomechanism

   The grey/green cylinder is the brush-type DC motor. The black section at the bottom contains the planetary reduction gear, and the black object on top of the motor is the optical rotary encoder for position feedback. Small R/C servo mechanism. 1. electric motor 2. position feedback potentiometer 3. reduction gear 4. actuator arm

6. Servo (radio control) - Wikipedia

   en.wikipedia.org/wiki/Servo_(radio_control)

   The servo is controlled by three wires: ground, power, and control. The servo will move based on the pulses sent over the control wire, which set the angle of the actuator arm. The servo expects a pulse every 20 ms in order to gain correct information about the angle. The width of the servo pulse dictates the range of the servo's angular motion.

7. Comparison of single-board microcontrollers - Wikipedia

   en.wikipedia.org/wiki/Comparison_of_single-board...

   Compatible With Arduino with servo ports - Added features: External DC power socket (7vdc to 20vdc) or USB powered. On board 5V regulator with heatsink area for efficient 1000mA output. Has built in ICSP port for on the fly programming (P1). Robotics Ready (Has 4 Servo ports P3 and P2). GSTduino Green System Technology [59] Yes ATmega328 16 MHz