enow.com Web Search

  1. Ads

    related to: square hydraulic hole punch

Search results

  1. Results from the WOW.Com Content Network
  2. Knockout punch - Wikipedia

    en.wikipedia.org/wiki/Knockout_punch

    Chassis punches: assorted sizes round and square Chassis punches: assorted sizes round and square disassembled. In metalworking, a knockout punch, also known as a chassis punch, panel punch, Greenlee punch, or a Q-max, [1] is a hand tool used to punch a hole through sheet metal. It is a very simple tool that consists of a punch, die, and screw.

  3. Hole punch - Wikipedia

    en.wikipedia.org/wiki/Hole_punch

    A hole punch, also known as hole puncher, or paper puncher, is an office tool that is used to create holes in sheets of paper, often for the purpose of collecting the sheets in a binder or folder (such collected sheets are called loose leaves). A hole punch can also refer to similar tools for other materials, such as leather, cloth, or sheets ...

  4. Punch (tool) - Wikipedia

    en.wikipedia.org/wiki/Punch_(tool)

    A punch is a tool used to indent or create a hole through a hard surface. They usually consist of a hard metal rod with a narrow tip at one end and a broad flat "butt" at the other. When used, the narrower end is pointed against a target surface and the broad end is struck with a hammer or mallet , causing the blunt force of the blow to be ...

  5. Types of press tools - Wikipedia

    en.wikipedia.org/wiki/Types_of_press_tools

    The compound tool differs from progressive and stage tools by the arrangement of the punch and die. It is an inverted tool where blanking and piercing takes place in a single stage and also the blanking punch will act as the piercing die. That means punch will be to the bottom side of the tool and piercing punches to top side of the tool.

  6. Punching - Wikipedia

    en.wikipedia.org/wiki/Punching

    A turret punch press houses punches and their corresponding dies in a revolving indexed turret, while a rail type punch stores tooling on a back rail out of the way of the workpiece. These machines use hydraulic as well as pneumatic power to press the shape with enough force to shear the metal.

  7. Punch press - Wikipedia

    en.wikipedia.org/wiki/Punch_press

    Punch presses are large machines with either a 'C' type frame, or a 'portal' (bridge) type frame. The C type has the hydraulic ram at the top foremost part, whereas the portal frame is much akin to a complete circle with the ram being centered within the frame to stop frame deflection or distortion.

  1. Ads

    related to: square hydraulic hole punch