Search results
Results from the WOW.Com Content Network
NodeMCU is a low-cost open source IoT platform. [ 4 ] [ 5 ] It initially included firmware which runs on the ESP8266 Wi-Fi SoC from Espressif Systems, and hardware which was based on the ESP-12 module.
ESP32 is a series of low-cost, low-power system-on-chip microcontrollers with integrated Wi-Fi and dual-mode Bluetooth.The ESP32 series employs either a Tensilica Xtensa LX6 microprocessor in both dual-core and single-core variations, an Xtensa LX7 dual-core microprocessor, or a single-core RISC-V microprocessor and includes built-in antenna switches, RF balun, power amplifier, low-noise ...
SparkFun ESP8266 Thing. The reason for the popularity of many of these boards over the earlier ESP-xx modules is the inclusion of an on-board USB-to-UART bridge (like the Silicon Labs' CP2102 or the WCH CH340G) and a Micro-USB connector, coupled with a 3.3-volt regulator to provide both power to the board and connectivity to the host (software development) computer – commonly referred to as ...
ESP Easy is a free and open source MCU firmware for the Internet of things (IoT). [1] and originally developed by the LetsControlIt.com community (formerly known as ESP8266.nu community). It runs on ESP8266 [2] Wi-Fi based MCU (microcontroller unit) platforms for IoT from Espressif Systems. The name "ESP Easy," by default, refers to the ...
This page was last edited on 6 December 2024, at 17:05 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may apply.
A low-power, wide-area network (LPWAN or LPWA network) is a type of wireless telecommunication wide area network designed to allow long-range communication at a low bit rate between IoT devices, such as sensors operated on a battery.
Dedicated short-range communications (DSRC) is a technology for direct wireless exchange of vehicle-to-everything (V2X) and other intelligent transportation systems (ITS) data between vehicles, other road users (pedestrians, cyclists, etc.), and roadside infrastructure (traffic signals, electronic message signs, etc.). [1]
However later in 2015, the owner of NodeMCU Inc handed over control of the NodeMCU firmware development to the community project which has actively developed and extended the firmware since, and this firmware is actively used by IoT developers.