Search results
Results from the WOW.Com Content Network
A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.
Point drainage, which intercepts water at gullies (points). Gullies connect to drainage pipes beneath the ground surface, so deep excavation is required to facilitate this system. Support for deep trenches is required in the shape of planking, strutting or shoring. Channel drainage, which intercepts water along the entire run of the channel.
A culvert under the Vistula river levee and a street in Warsaw. Construction or installation at a culvert site generally results in disturbance of the site's soil, stream banks, or stream bed, and can result in the occurrence of unwanted problems such as scour holes or slumping of banks adjacent to the culvert structure.
It is a very important safety factor. Cross slope is provided to provide a drainage gradient so that water will run off the surface to a drainage system such as a street gutter or ditch. Inadequate cross slope will contribute to aquaplaning.
A trench drain (also known as a channel drain, line drain, slot drain, linear drain, or strip drain) is a specific type of floor drain featuring a trough- or channel-shaped body. It is designed for the rapid evacuation of surface water or for the containment of utility lines or chemical spills.
Invert level affects flow from drainage pipes In civil engineering , the invert level is the base interior level of a pipe, trench or tunnel ; it can be considered the "floor" level. [ 1 ] The invert is an important datum for determining the functioning or flowline of a piping system.
Sanitary manholes should be constructed at locations where there is a change from a simple straight sewer line. These include all junctions that combine multiple lines into one or split from one, bends, changing in elevation, changing in pipe size, and changing in pipe type.
Connecting to an existing water line (white pipe) with a stainless steel tapping sleeve and valve (red). A concrete thrust block is being formed behind the new connection. Water pipe connected to the septic tank .