Search results
Results from the WOW.Com Content Network
A Block and bleed manifold is a hydraulic manifold that combines one or more block/isolate valves, usually ball valves, and one or more bleed/vent valves, usually ball or needle valves, into one component for interface with other components (pressure measurement transmitters, gauges, switches, etc.) of a hydraulic system. The purpose of the ...
This may comprise a ‘double block’ consisting of two valves in series. Still more effective is a ‘double block and bleed’ comprising two isolation valves in series plus a bleed valve between them. The bleed valve enables the integrity of the valve on the hazardous side to be monitored. [5]
A double check valve or double check assembly (DCA) is a backflow prevention device designed to protect water supplies from contamination. [1] It is different from the two-way check valves (sometimes erroneously referred to as double check valves) used in air brake systems on heavy trucks which select from the highest pressure source.
Automatic valves are used to release trapped air as it collects. They are not a substitute for bleeding a system manually when it is first filled during commissioning, nor for remedial bleeding if the system becomes choked with trapped air. In those cases, individual bleed screws on each radiator, or high pipe run, are opened manually.
DBB – double block and bleed; DBP – drillable bridge plug; DBR – damaged beyond repair; DCA – decline curve analysis; DC – drill centre; DC – drill collar/collars; DCAL – dual caliper log; DCC – distance cross course; DCS – distributed control system; DD – directional driller or directional drilling; DDC – daily drilling cost
double-acting cylinder - Energy is stored using a volume of compressed fluid The type of actuation required depends upon the application, site facilities and also the physical space available although the majority of actuators used for shutdown valves are of the spring return type due to the fail safe nature of spring return systems.
In order to achieve both good adjacent channel selectivity and image rejection, the double-conversion receiver uses two intermediate frequencies (IFs). The incoming radio frequency (RF) signal from the antenna is first mixed with a sinusoidal signal from the 1st local oscillator (LO) to give a high 1st IF frequency. Since the separation between ...
A block and tackle [1] [2] or only tackle [3] is a system of two or more pulleys with a rope or cable threaded between them, usually used to lift heavy loads.. The pulleys are assembled to form blocks and then blocks are paired so that one is fixed and one moves with the load.