enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. JST connector - Wikipedia

   en.wikipedia.org/wiki/JST_connector

   JST manufactures numerous series (families) and pitches (pin-to-pin distance) of connectors. [ 2 ] [ 3 ] JST connectors are used in many types of products, and commonly used by electronics hobbyists and consumer products for rechargeable battery packs, battery balancers , battery eliminator circuits , 3D printers , and radio controlled servos .

3. Molex connector - Wikipedia

   en.wikipedia.org/wiki/Molex_connector

   18 AWG, or 0.823 mm 2 wire is typically used. AMP Mate-n-Lok and Molex 8981 0.093-inch pin and socket power connectors Molex standard 0.093-inch pin and socket connectors Molex disk drive power connection system tool and connectors Molex Mini-Fit Jr. connector as used for ATX power supply

4. D-subminiature - Wikipedia

   en.wikipedia.org/wiki/D-subminiature

   "25 pin D-SUB male connector diagram and applications". Archived from the original on 2009-10-05 Comprehensive DB-25 wiring diagrams: Tascam, Apple, SCSI, etc. "Pinouts by Connector". Pinouts. A list of common computer connectors, including most D-sub. "9 pin D-SUB female connector diagram and applications". Pinouts.

5. NEMA connector - Wikipedia

   en.wikipedia.org/wiki/NEMA_connector

   The addition is a 3 ⁄ 16-inch (4.8 mm) diameter round or U-shaped ground pin, 1 ⁄ 8 in (3.2 mm) longer than the power blades (so the device is grounded before the power is connected) and located from them by 1 ⁄ 4 in (6.4 mm) edge-to-edge or 15 ⁄ 32 in (11.9 mm) center-to-center.

6. FASTON terminal - Wikipedia

   en.wikipedia.org/wiki/FASTON_terminal

   There are free-hanging wire and circuit board mounted versions of both tabs and receptacles. All widths come mostly in one of two tab thicknesses: 0.032 and 0.020 in (0.8 and 0.5 mm). All widths come mostly in one of two tab thicknesses: 0.032 and 0.020 in (0.8 and 0.5 mm).

7. Twist-on wire connector - Wikipedia

   en.wikipedia.org/wiki/Twist-on_wire_connector

   [4] Special feedthrough twist-on wire connectors differ from standard wire connectors in that they have an additional opening at the top of the insulated cap. This allows a single-conductor bare wire to be pushed through the hole, forming a "pigtail" section which can be attached to a grounding screw.