Search results
Results from the WOW.Com Content Network
The 16-pin 12VHPWR connector is a standard for connecting graphics processing units (GPUs) to computer power supplies for up to 600 W power delivery. It was introduced in 2022 to supersede the previous 6- and 8-pin power connectors for GPUs. The primary aim was to cater to the increasing power requirements of high-performance GPUs.
PS-ON Signal is a pin on a 20-pin or 24-pin ATX-specified power connector used to turn a personal computer power supply unit on/off. The PS_ON pin is normally pulled high in an open-circuit, but will turn on the power supply when it is pulled low, by shorting it to the common signal (COM). Conversely the power supply is turned off when the PS ...
IC power-supply pins are voltage and current supply terminals found on integrated circuits (ICs) in electrical engineering, electronic engineering, and integrated circuit design. [ a ] ICs have at least two pins that connect to the power rails of the circuit in which they are installed.
A power supply with a 24-pin connector can be used on a motherboard with a 20-pin connector. In cases where the motherboard has a 24-pin connector, some power supplies come with two connectors (one with 20-pin and other with 4-pin, i.e. 20+4-pin form) which can be used together to form the 24-pin connector.
(A few early original PlayStation models featured RCA outs for composite video and stereo analog audio in addition to the AV Multi connector.) 35-pin MicroCross Molex connector VESA Enhanced Video Connector and VESA Plug and Display (a.k.a. M1-DA) both used this connector with slightly different pin assignments. These schemes combined VGA or ...
The Cisco Supervisor Engine serves as the management card for modular Cisco switches that can also, in some cases, act as forwarding/routing element. [1]Over time, the Supervisor Engine has undergone multiple iterations and was different for different modular switches in Cisco Portfolio (Catalyst 4000, 4500, 5000, 5500, 6000, 6500, 9400, 9600 and Nexus switches).
SCSI hard drives showing 80-pin SCA connector (top), and separate 68-pin and power connectors plus configuration jumpers (bottom) SCSI backplane with 80-pin SCA connectors. Hard Drives are mounted on proprietary hot-swappable caddies. Single Connector Attachment, or SCA, is a type of connection for the internal cabling of Parallel SCSI systems ...
12 early ISA 8 bit and 16 bit PC network cards. The lower right-most card is an early wireless network card, and the central card with partial beige plastic cover is a PSTN modem. Intel Ophir 82571 dual-port Gigabit Ethernet controller die. Network controllers were originally implemented as expansion cards that plugged into a computer bus.