Search results
Results from the WOW.Com Content Network
It is one type of read-only memory (ROM). PROMs are used in digital electronic devices to store permanent data, usually low level programs such as firmware or microcode. The key difference from a standard ROM is that the data is written into a ROM during manufacture, while with a PROM the data is programmed into them after manufacture. Thus ...
Firmware is stored in non-volatile memory – either read-only memory (ROM) or programmable memory such as EPROM, EEPROM, or flash. Changing a device's firmware stored in ROM requires physically replacing the memory chip – although some chips are not designed to be removed after manufacture.
Read-only memory (ROM) is a type of non-volatile memory used in computers and other electronic devices. Data stored in ROM cannot be electronically modified after the manufacture of the memory device. Read-only memory is useful for storing software that is rarely changed during the life of the system, also known as firmware.
Flashrom is a software utility published under an open source license that can detect, read, verify, erase, or write EEPROMs using interfaces such as the Low Pin Count (LPC), FWH, parallel, and Serial Peripheral Interface (SPI). It can be used to flash firmware images such as BIOS or coreboot, or to backup existing firmware.
EEPROM or E 2 PROM (electrically erasable programmable read-only memory) is a type of non-volatile memory. It is used in computers, usually integrated in microcontrollers such as smart cards and remote keyless systems, or as a separate chip device, to store relatively small amounts of data by allowing individual bytes to be erased and reprogrammed.
Boot ROM is a piece of read-only memory (ROM) that is used for booting a computer system. [1] It contains instructions that are run after the CPU is reset to the reset vector , and it typically loads a bootloader .
An EPROM (rarely EROM), or erasable programmable read-only memory, is a type of programmable read-only memory (PROM) chip that retains its data when its power supply is switched off. Computer memory that can retrieve stored data after a power supply has been turned off and back on is called non-volatile .
EEPROM (Electrically erasable programmable read-only memory) – In this type the data can be rewritten electrically, while the chip is on the circuit board, but the writing process is slow. This type is used to hold firmware , the low level microcode which runs hardware devices, such as the BIOS program in most computers, so that it can be ...