enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Reamer - Wikipedia

   en.wikipedia.org/wiki/Reamer

   A tapered reamer may be used for cleaning burrs from a drilled hole, or to enlarge a hole. The body of the tool tapers to a point. This type of reamer consists of a body which, typically, is up to 1/2 inch in diameter, with a rod cross piece at the large end acting to form a handle.

3. Bead roller - Wikipedia

   en.wikipedia.org/wiki/Bead_roller

   A bead roller is a machine tool that makes rigid lines in sheet metal to make surfaces more rugged and durable. The lines bead rollers add to sheet metal prevent warping and disfigurement by adding structural integrity to the metal.

4. Boring (manufacturing) - Wikipedia

   en.wikipedia.org/wiki/Boring_(manufacturing)

   A part's-eye view of a boring bar. Hole types: Blind hole (left), through hole (middle), interrupted hole (right). In machining, boring is the process of enlarging a hole that has already been drilled (or cast) by means of a single-point cutting tool (or of a boring head containing several such tools), such as in boring a gun barrel or an engine cylinder.

5. Hole opener - Wikipedia

   en.wikipedia.org/wiki/Hole_opener

   Heavy-duty roller cones hole opener used for offshore drilling. A hole opener is a device used to enlarge the borehole during a well drilling operation. It can be positioned either above the drill bit or above a pilot run inside the existing borehole. Usages range from hydrocarbon drilling operations to water drilling or horizontal drilling.

6. Tailstock - Wikipedia

   en.wikipedia.org/wiki/Tailstock

   Holes can only be cut along the axis that the workpiece is set to spin. [2] Usually, the entire tailstock is moved to the approximate position that it will be needed by manually sliding it along its ways. There, it is locked in place and the tool mounted to it is moved with a leadscrew to the exact position where it is needed. When a cutting ...

7. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   A drill chuck is a specialised self-centering, three-jaw chuck, usually with capacity of 0.5 in (13 mm) or less, and rarely greater than 1 in (25 mm), used to hold drill bits or other rotary tools. This type of chuck is used on tools ranging from professional equipment to inexpensive hand and power drills for domestic use.

8. Automatic tool changer - Wikipedia

   en.wikipedia.org/wiki/Automatic_Tool_Changer

   But if even more tools are required, then an ATC is needed. The tools are stored in a magazine. This allows the machine to work with a large number of tools without operator intervention. The main parts of an automatic tool changer are the base, the gripper arm, the tool holder, the support arm, and the tool magazines. [2]

9. Machine taper - Wikipedia

   en.wikipedia.org/wiki/Machine_taper

   Spindle nose on a lathe headstock. The small female taper is a Morse taper to take a lathe center or a tool such as a twist drill. The large male taper takes a lathe chuck, which is retained by the large nut. A machine taper is a system for securing cutting tools or toolholders in the spindle of a machine tool or power tool.