enow.com Web Search

  1. Ads

    related to: installing carpet transition strip

Search results

  1. Results from the WOW.Com Content Network
  2. Tack strip - Wikipedia

    en.wikipedia.org/wiki/Tack_strip

    Tack strip being removed from a floor. Tack strip also known as gripper rod, carpet gripper, Smoothedge tackless strip, gripper strip or gripper edge is a thin piece of wood, between 1 and 2 metres (3.3 and 6.6 ft) long and about 3 centimetres (1.2 in) wide, studded with hundreds of sharp nails or tacks used in the installation of carpet.

  3. Fitted carpet - Wikipedia

    en.wikipedia.org/wiki/Fitted_carpet

    A "carpet gripper" tack strip, for a fitted carpet. The introduction of tack strip, "tackless strip", "gripper strip", or "Smoothedge" simplified the installation of wall-to-wall carpeting, increasing the neatness of the finish at the wall. Because gripper strips are essentially the same thickness as underlay, using gripper strips yields a ...

  4. Flooring - Wikipedia

    en.wikipedia.org/wiki/Flooring

    Flooring is the general term for a permanent covering of a floor, or for the work of installing such a floor covering. Floor covering is a term to generically describe any finish material applied over a floor structure to provide a walking surface. Both terms are used interchangeably but floor covering refers more to loose-laid materials.

  5. The AOL.com video experience serves up the best video content from AOL and around the web, curating informative and entertaining snackable videos.

  6. Piling - Wikipedia

    en.wikipedia.org/wiki/Piling

    A transition piece (complete with pre-installed features such as boat-landing arrangement, cathodic protection, cable ducts for sub-marine cables, turbine tower flange, etc.) is attached to the driven pile, and the sand and water are removed from the centre of the pile and replaced with concrete. An additional layer of even larger stone, up to ...

  7. Lath and plaster - Wikipedia

    en.wikipedia.org/wiki/Lath_and_plaster

    It consists of narrow strips of wood which are nailed horizontally across the wall studs or ceiling joists and then coated in plaster. The technique derives from an earlier, more primitive process called wattle and daub. [1] Lath and plaster largely fell out of favour in the U.K. after the introduction of plasterboard in the 1930s. [2]

  1. Ads

    related to: installing carpet transition strip