Search results
Results from the WOW.Com Content Network
The General Motors 60° V6 engine family is a series of 60° V6 engines produced for both longitudinal and transverse applications. All of these engines are 12-valve cam-in-block or overhead valve engines, except for the LQ1 which uses 24 valves driven by dual overhead cams. These engines vary in displacement between 2.8 and 3.4 litres (2,837 ...
The GM High Feature engine (also known as the HFV6, and including the 3600 LY7 and derivative LP1) is a family of modern DOHC V6 engines produced by General Motors. The series was introduced in 2004 with the Cadillac CTS and the Holden Commodore (VZ). It is a 60° 24-valve design with aluminum block and heads and sequential multi-port fuel ...
The Ford Cologne V6 is a series of 60° cast iron block V6 engines produced by the Ford Motor Company from 1962 to 2011 in displacements between 1.8 L; 110.6 cu in (1,812 cc) and 4.0 L; 244.6 cu in (4,009 cc).
The GMC V6 is a family of 60-degree V6 engines produced by the GMC division of General Motors from 1959 through 1974. It was developed into both gasoline and diesel versions, and produced in V8 and V12 derivatives. Examples of this engine family were found in pickup trucks, Suburbans, heavier trucks, and motor coaches.
1984-1999 Nissan VG30E 60-degree engine Toyota 1GR-FE 4.0 Litre 60-degree V6 Engine. A V-angle of 60 degrees is the optimal configuration for V6 engines regarding engine balance. [4] When individual crank pins are used for each cylinder (i.e. using a six-throw crankshaft), an even firing interval of 120 degrees can be used.
Being nearly identical, it too has the distinctive odd-sided hexagonal shape. These engines can be fitted in rear wheel drive vehicles with the right bellhousing and are used in hot rods, kit cars, sand rails and late model engine swaps. All Cadillac Northstar V8s; Oldsmobile Aurora L47 V8; GM 3.5L LX5 "Short Star" V6
The High Value engine family from General Motors is a group of cam-in-block or overhead valve V6 engines.These engines feature cast iron blocks and aluminum heads, and use the same 60° vee bank as the 60° V6 family they are based on, but the new 99 mm (3.90 in) bore required offsetting the bores by 1.5 mm (0.059 in) away from the engine center line.
The J-series engine was designed in the United States by Honda engineers. It is built at Honda's Anna, Ohio, and Lincoln, Alabama, engine plants. The J-series is a 60° V6 unlike Honda's existing 90° C-series engines. Also unlike the C series, the J-series was specifically and only designed for transverse mounting.