Search results
Results from the WOW.Com Content Network
A gain greater than one (greater than zero dB), that is, amplification, is the defining property of an active device or circuit, while a passive circuit will have a gain of less than one. [4] The term gain alone is ambiguous, and can refer to the ratio of output to input voltage (voltage gain), current (current gain) or electric power (power ...
Schematic of an AGC used in the analog telephone network; the feedback from output level to gain is effected via a Vactrol resistive opto-isolator.. Automatic gain control (AGC) is a closed-loop feedback regulating circuit in an amplifier or chain of amplifiers, the purpose of which is to maintain a suitable signal amplitude at its output, despite variation of the signal amplitude at the input.
For these amplifiers, the 1 dB compression point is defined as the input power (or output power) where the gain is 1 dB less than the small signal gain. Sometimes this non linearity is deliberately designed in to reduce the audible unpleasantness of hard clipping under overload. Ill effects of non-linearity can be reduced with negative feedback.
Tuning a control loop is the adjustment of its control parameters (proportional band/gain, integral gain/reset, derivative gain/rate) to the optimum values for the desired control response. Stability (no unbounded oscillation) is a basic requirement, but beyond that, different systems have different behavior, different applications have ...
The input charge and the output voltage are proportional with inverted sign. The feedback capacitor C f sets the amplification. = = The input impedance of the circuit is almost zero because of the Miller effect. Hence all the stray capacitances (the cable capacitance, the amplifier input capacitance, etc.) are virtually grounded and they have ...
The channel input strips are usually a bank of identical monaural or stereo input channels arranged in columns. Typically, each channel's column contains a number of rotary potentiometer knobs, buttons, and faders for controlling the gain of the input preamplifier, adjusting the equalization of the signal on each channel, controlling routing of the input signal to other functional sections ...
Below, the voltage gain of the amplifier with feedback, the closed-loop gain A FB, is derived in terms of the gain of the amplifier without feedback, the open-loop gain A OL and the feedback factor β, which governs how much of the output signal is applied to the input (see Figure 1). The open-loop gain A OL in general may be a function of both ...
The "P" (proportional) gain, is then increased (from zero) until it reaches the ultimate gain, at which the output of the control loop has stable and consistent oscillations. K u {\displaystyle K_{u}} and the oscillation period T u {\displaystyle T_{u}} are then used to set the P, I, and D gains depending on the type of controller used and ...