Search results
Results from the WOW.Com Content Network
This is the simplest arrangement of masonry units. If the wall is two wythes thick, one header is used to bind the two wythes together. [3] Header course: This is a course made up of a row of headers. [1] Bond course: This is a course of headers that bond the facing masonry to the backing masonry. [1] Plinth: The bottom course of a wall.
A water table is a projection of lower masonry on the outside of a wall, slightly above the ground, or at the top of a wainscot section of a wall (in this case also known as a sill). It is both a functional and architectural feature that consists of a projection that deflects water running down the face of a building away from lower courses or ...
A slurry wall is a civil engineering technique used to build reinforced concrete walls in areas of soft earth close to open water, or with a high groundwater table. [1] This technique is typically used to build diaphragm (water-blocking) walls surrounding tunnels and open cuts, and to lay foundations .
A load-bearing wall or bearing wall is a wall that is an active structural element of a building — that is, it bears the weight of the elements above said wall, resting upon it by conducting its weight to a foundation structure. [1] The materials most often used to construct load-bearing walls in large buildings are concrete, block, or brick.
The term is based on the word "whet", which means to sharpen a blade, [3] [4] not on the word "wet". The verb nowadays to describe the process of using a sharpening stone for a knife is simply to sharpen, but the older term to whet is still sometimes used, though so rare in this sense that it is no longer mentioned in, for example, the Oxford Living Dictionaries.
A leaf is as thick as the width of one brick, but a wall is said to be one brick thick if it as wide as the length of a brick. Accordingly, a single-leaf wall is a half brick thickness; a wall with the simplest possible masonry transverse bond [definition needed] is said to be one brick thick, and so on. [21]
The conservation and restoration of woodblock prints, is the process of caring for and repairing images made from a specific printing process involving using wooden reliefs to stamp or imprint an image onto paper.
Flowstones are sheetlike deposits of calcite or other carbonate minerals, formed where water flows down the walls or along the floors of a cave. [1] They are typically found in "solution caves", in limestone, where they are the most common speleothem. However, they may form in any type of cave where water enters that has picked up dissolved ...