Search results
Results from the WOW.Com Content Network
A flexplate or flex plate is a metal disk that connects the output from an engine to the input of a torque converter in a car equipped with an automatic transmission. [1] It takes the place of the flywheel found in a conventional manual transmission setup.
Cutaway view of a 2007 Toyota AA80E hydraulic automatic Typical gear selector for an automatic transmission. An automatic transmission (sometimes abbreviated AT) is a multi-speed transmission used in motor vehicles that does not require any input from the driver to change forward gears under normal driving conditions.
A direct-shift gearbox (DSG, German: Direktschaltgetriebe [1]) [2] [3] is an electronically controlled, dual-clutch, [2] multiple-shaft, automatic gearbox, in either a transaxle or traditional transmission layout (depending on engine/drive configuration), with automated clutch operation, and with fully-automatic [2] or semi-manual gear selection.
GM's Automatic Safety Transmission (AST) was a semi-automatic transmission released in 1937. The first mass-produced fully-automatic transmission developed for passenger automobile use was the GM Hydramatic introduced in 1940. [1] The Hydramatic was a big success, and had been installed in the majority of GM models by 1950.
This was quickly changed to "Hondamatic". This gearbox was a separate unit and used ATF - Automatic Transmission Fluid. The company's naming scheme is also confusing, as it is specific to a single model of the vehicle and some identifiers are reused. Below is a list of Honda automatic transmissions: [4] 1973–1979 H2 — 2-speed
Toyota Motor Corporation's A family is a family of automatic FWD/RWD/4WD/AWD transmissions built by Aisin-Warner.They share much in common with Volvo's AW7* and Aisin-Warner's 03-71* transmissions, which are found in Suzukis, Mitsubishis, and other Asian vehicles.
Transmission broadcast codes in 2005 for the ECCC transmission are 5ABN and 5MMN. [1] The 4T80-E is a hydramatic transmission and was developed for use with V8 front-wheel-drive cars, and at the time exclusively the Cadillac Northstar engine. [3] It was designed with extreme power handling capabilities at the time.
In a vehicle with an automatic transmission, the torque converter connects the prime mover to the automatic gear train, which then drives the load. It is thus usually located between the engine's flexplate and the transmission. The equivalent device in a manual transmission is the mechanical clutch.