Ad
related to: 30cm x 50cm frame data
Search results
Results from the WOW.Com Content Network
The primary function of the Fabric is to receive the frames from the source port and route them to the destination port. It is the FC-2 layer's responsibility to break the data to be transmitted into frame size, and reassemble the frames. Each frame begins and ends with a frame delimiter. The frame header immediately follows the Start of Frame ...
In the OSI model of computer networking, a frame is the protocol data unit at the data link layer. Frames are the result of the final layer of encapsulation before the data is transmitted over the physical layer. [1] A frame is "the unit of transmission in a link layer protocol, and consists of a link layer header followed by a packet."
Ethernet packet. The SFD (start frame delimiter) marks the end of the packet preamble. It is immediately followed by the Ethernet frame, which starts with the destination MAC address. [1] In computer networking, an Ethernet frame is a data link layer protocol data unit and uses the underlying Ethernet physical layer transport
It is set to 1 in a non-QoS data frame transmitted by a non-QoS WLAN station to indicate the frame being transmitted is using Strictly-Ordered service class (this use is obsolete and will be removed from the future 802.11 Standard).
Individual frames are then "minor frames" within that superframe. Each frame contains a subframe ID (often a simple counter) which identifies its position within the superframe. A second frame synchronizer establishes superframe synchronization. This allows subcommutation, where some data is sent less frequently than every frame.
A data link connection identifier (DLCI) is a Frame Relay 10-bit-wide link-local virtual circuit identifier used to assign frames to a specific PVC or SVC. Frame Relay networks use DLCIs to statistically multiplex frames. DLCIs are preloaded into each switch and act as road signs to the traveling frames. [1] The standard allows the existence of ...
EtherType is a two-octet field in an Ethernet frame. It is used to indicate which protocol is encapsulated in the payload of the frame and is used at the receiving end by the data link layer to determine how the payload is processed. The same field is also used to indicate the size of some Ethernet frames.
A GFP client frame can be further classified as either a client data frame or a client management frame. The former is used to transport client data, while the latter is used to transport point-to-point management information like loss of signal, etc. Client management frames can be differentiated from the client data frames based on the ...
Ad
related to: 30cm x 50cm frame data