Search results
Results from the WOW.Com Content Network
Ford — Dual-Stage Intake (DSI), on their Duratec 2.5 and 3.0-litre V6s, and it was also found on the Yamaha V6 in the Taurus SHO. The Ford Modular V8 engines and the V6 Cologne use either the Intake Manifold Runner Control (IMRC) for four-valve engines, or the Charge Motion Control Valve (CMCV) for three-valve engines.
Carburetors used as intake runners A cutaway view of the intake of the original Fordson tractor (including the intake manifold, vaporizer, carburetor, and fuel lines). An inlet manifold or intake manifold (in American English) is the part of an internal combustion engine that supplies the fuel/air mixture to the cylinders. [1]
Control of a MultiAir engine's intake valves works via a valve tappet (cam follower), moved by a mechanical intake cam, which is connected to the intake valve through a hydraulic chamber, controlled by a normally open on/off solenoid valve. [11] The system allows optimum timing of intake valve operation.
Swirl flap principle in a four-valve engine. A swirl flap is a small butterfly valve fitted to four-stroke internal combustion engines with at least two intake valves.It is installed inside or just before one of a cylinder's two intake ports, allowing to throttle its intake port's air flow, causing a swirl in the other intake port not fitted with a swirl flap.
Diagram of a DOHC straight-four engine 1989-2006 Ford I4 DOHC engine with the cylinder head removed 2006-2009 Nissan M9R diesel engine. A straight-four engine (also referred to as an inline-four engine) is a four-cylinder piston engine where cylinders are arranged in a line along a common crankshaft.
We are just days from the Indianapolis 500 and the starting grid is set.. After two days of qualifying, Scott McLaughlin earned the pole position at 234.220 mph for his 4-lap run around the 2.5 ...
A replacement automobile engine is an engine or a major part of one that is sold individually without any other parts required to make a functional car (for example a drivetrain). These engines are produced either as aftermarket parts or as reproductions of an engine that has gone out of production.
So in the Miller cycle engine, the piston actually compresses the fuel-air mixture only during the latter 70% to 80% of the compression stroke. During the initial part of the compression stroke, the piston pushes part of the fuel-air mixture through the still-open intake valve, and back into the intake manifold.