Ads
related to: throttle position sensor potentiometer arduino
Search results
Results from the WOW.Com Content Network
A throttle position sensor (TPS) is a sensor used to monitor the throttle body valve position for the ECU of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle. More advanced forms of the sensor are also used. For example, an extra "closed throttle position ...
Electronic throttle control (ETC) is an automobile technology that uses electronics to replace the traditional mechanical linkages between the driver's input such as a foot pedal to the vehicle's throttle mechanism which regulates speed or acceleration. This concept is often called drive by wire, [1][2] and sometimes called accelerate-by-wire ...
A potentiometer is a three- terminal resistor with a sliding or rotating contact that forms an adjustable voltage divider. [1] If only two terminals are used, one end and the wiper, it acts as a variable resistor or rheostat. The measuring instrument called a potentiometer is essentially a voltage divider used for measuring electric potential ...
A position sensor is a sensor that detects an object's position. A position sensor may indicate the absolute position of the object (its location) or its relative position (displacement) in terms of linear travel, rotational angle or three-dimensional space. Common types of position sensors include the following: Capacitive displacement sensor
Rotary encoder. A Gray code absolute rotary encoder with 13 tracks. At the top, the housing, interrupter disk, and light source can be seen; at the bottom the sensing element and support components. A rotary encoder, also called a shaft encoder, is an electro-mechanical device that converts the angular position or motion of a shaft or axle to ...
The servo is controlled by three wires: ground, power, and control. The servo will move based on the pulses sent over the control wire, which set the angle of the actuator arm. The servo expects a pulse every 20 ms in order to gain correct information about the angle. The width of the servo pulse dictates the range of the servo's angular motion.
String potentiometers are used to measure the position of a moving object. The measurement cable can be connected directly to the moving part, giving a constant measurement of its linear position. This simple type of measurement device has been in use by engineers and designers for about 40 years. [citation needed]
Potentiometric sensor. A potentiometric sensor is a type of chemical sensor that may be used to determine the analytical concentration of some components of the analyte gas or solution. These sensors measure the electrical potential of an electrode when no current is present.
Ads
related to: throttle position sensor potentiometer arduino