Search results
Results from the WOW.Com Content Network
Laurell Technologies WS-400 spin coater used to apply photoresist to the surface of a silicon wafer. Spin coating is a procedure used to deposit uniform thin films onto flat substrates. Usually a small amount of coating material in liquid form is applied on the center of the substrate, which is either spinning at low speed or not spinning at all.
Modern automobile paint is applied in several layers, with a total thickness of around 100 μm (0.1mm). Paint application requires preparation and primer steps to ensure proper application. A basecoat is applied after the primer paint is applied. Following this, a clearcoat of paint may be applied that forms a glossy and transparent coating.
Axalta traces its origins to the German firm Herberts Gmbh, which began in 1866 coating carriages before moving to automotive painting. Through later mergers the company became DuPont Performance Coatings (DPC), part of the American DuPont chemical empire, and was rebranded as Axalta Coating Systems after being purchased by The Carlyle Group in ...
There are four basic parameters that are involved in spin coating: solution viscosity, solid content (density), angular speed, and spin time. [13] A range of thicknesses can be achieved by spin coating. Most commonly the thicknesses range from 1-200 μm. The main properties that affect the thickness of the film are viscosity and spin speed.
Spin casting is a favored method for fabricating items in the specified materials – low temperature metals and thermoset plastics. Compared to the two main competing processes, injection molding and (zinc) die-casting, spin casting has significant advantages in terms of startup cost and ease of use.
Spraying. The coating material is applied to the parts' surface using a spray gun. This can be done manually or in a fully automated spraying facility (this process is used for larger or unwieldy parts, also termed rack parts, as they are brought into the coating process on a rack). Dip-spinning. The parts get loaded into a basket.
Slot-die coating is a non-contact coating method, in which the slot-die is typically held over the substrate at a height several times higher than the target wet film thickness. [23] The coating fluid transfers from the slot-die to the substrate via a fluid bridge that spans the air gap between the slot-die lips and substrate surface.
Aerial view of the Ford Arizona Proving Ground. Latitude and longitude: The Arizona Proving Ground opened in 1985. The Proving Ground consists of 1,498 acres (6.06 km 2) located less than one hour northwest of the Phoenix Sky Harbor Airport at an elevation of 1,650 feet (500 m).