Search results
Results from the WOW.Com Content Network
The ATX specification requires that the power-good signal ("PWR_OK") go high no sooner than 100 ms after the power rails have stabilized, and remain high for 16 ms after loss of AC power, and fall (to less than 0.4 V) at least 1 ms before the power rails fall out of specification (to 95% of their nominal value).
PS-ON Signal is a pin on a 20-pin or 24-pin ATX-specified power connector used to turn a personal computer power supply unit on/off. The PS_ON pin is normally pulled high in an open-circuit, but will turn on the power supply when it is pulled low, by shorting it to the common signal (COM).
Main page; Contents; Current events; Random article; About Wikipedia; Contact us
Standby power may be used to power a display, operate a clock, etc., without switching the equipment to full power. Battery-powered equipment connected to mains electricity can be kept fully charged although switched on; for example, a mobile telephone can be ready to receive calls without depleting its battery charge.
The message is encountered when printing on older HP LaserJet printers such as the LaserJet II, III, and 4 series. It means that the printer is trying to print a document that needs "Letter size" (8½ × 11 in.) paper when no such paper is available. [3] Early LaserJet models used a two-character display for all status messages.
In the context of an operating system, a device driver is a computer program that operates or controls a particular type of device that is attached to a computer or automaton. [1] A driver provides a software interface to hardware devices, enabling operating systems and other computer programs to access hardware functions without needing to ...
This way the noise covers a bandwidth that is much wider than the signal itself. The resulting signal influence relies mainly on the filtering of the noise. To describe the signal quality without taking the receiver into account, the optical SNR (OSNR) is used. The OSNR is the ratio between the signal power and the noise power in a given bandwidth.
Digital RGB addressable LEDs contain their own "smart" control electronics. In addition to power and ground, these provide connections for data-in, data-out, clock and sometimes a strobe signal. These are connected in a daisy chain, which allows individual LEDs in a long LED strip light to be easily controlled by a microcontroller. Data sent to ...