Search results
Results from the WOW.Com Content Network
The ATX specification requires that the power-good signal ("PWR_OK") go high no sooner than 100 ms after the power rails have stabilized, and remain high for 16 ms after loss of AC power, and fall (to less than 0.4 V) at least 1 ms before the power rails fall out of specification (to 95% of their nominal value).
To allow for voltage drops, the voltage at the host port, hub port, and device are specified to be at least 4.75 V, 4.4 V, and 4.35 V respectively by USB 2.0 for low-power devices, [a] but must be at least 4.75 V at all locations for high-power [b] devices (however, high-power devices are required to operate as a low-powered device so that they ...
PS-ON Signal is a pin on a 20-pin or 24-pin ATX-specified power connector used to turn a personal computer power supply unit on/off. The PS_ON pin is normally pulled high in an open-circuit, but will turn on the power supply when it is pulled low, by shorting it to the common signal (COM).
Samsung Notebook, formerly known as Samsung Sens (삼성 센스), also marketed as Samsung Notebook Series (2011–2013), is a line of portable computers produced by Samsung Electronics. The Sens line was first launched in 1995 and lasted until 2013, exported overseas without the Sens branding, and replaced by Samsung Ativ .
In addition to an empty PCIe slot on the motherboard, many "PCI Express to USB 3.0" expansion cards must be connected to a power supply such as a Molex adapter or external power supply, in order to power many USB 3.0 devices such as mobile phones, or external hard drives that have no power source other than USB; as of 2011, this is often used ...
USB-C plug USB-C (SuperSpeed USB 5Gbps) receptacle on a laptop. USB-C, or USB Type-C, is a 24-pin, reversible connector (not a protocol) that supersedes previous USB connectors and can carry audio, video, and other data, to connect to monitors, external drives, hubs/docking stations, mobile phones, and many more peripheral devices.
It only occurs because some devices claim to be "switched off" on the electronic interface but are in a different state. Switching off the plug or disconnecting it from the power point can completely solve the problem of standby power. Switching off the power point is effective enough; there is no need to disconnect all devices from the power ...
The message is encountered when printing on older HP LaserJet printers such as the LaserJet II, III, and 4 series. It means that the printer is trying to print a document that needs "Letter size" (8½ × 11 in.) paper when no such paper is available. [3] Early LaserJet models used a two-character display for all status messages.