Search results
Results from the WOW.Com Content Network
Plastic is the generic name for a family of synthetic materials derived from petrochemicals.It is often product of two or more components. There are many families of plastics and polymers being used in construction industry, such as acrylics, composites, expanded polystyrene, polycarbonates, polyethylene, polypropylene, and polyvinyl chloride.
Styrofoam insulation extruded polystyrene foam (XPS), owned and manufactured by DuPont. Styrofoam is a genericized trademarked brand of closed-cell extruded polystyrene foam (XPS), manufactured to provide continuous building insulation board used in walls, roofs, and foundations as thermal insulation and as a water barrier.
In the United States, the International Building Code and ASTM International define Exterior Insulation and Finish System (EIFS) as a non-load-bearing exterior wall cladding system that consists of an insulation board attached either adhesively, mechanically, or both, to the substrate; an integrally reinforced base coat; and a textured protective finish coat.
Large openings in conventional construction require large headers and supporting posts, whereas ICF construction reduces the cost, as only reinforcing steel is needed directly around the opening. ICF construction can allow up to 60% smaller heating and cooling units to service the same floor area, which can cut the cost of the final house by an ...
Smaller sections ease transportation and handling, but the use of the largest panel possible will create the best insulated building. At 15−20 kg/m 2, longer panels can become difficult to handle without the use of a crane to position them, and this is a consideration that must be taken into account due to cost and site limitations. Also of ...
For example, in the US the insulation standard for attics, is recommended to be at least R-38 US units, (equivalent to R-6.7 or a U value of 0.15 in SI units). [5] The equivalent standard in the UK are technically comparable, the approved document L would normally require an average U value over the roof area of 0.11 to 0.18 depending on the ...
In construction, cladding is used to provide a degree of thermal insulation and weather resistance, and to improve the appearance of buildings. [1] Cladding can be made of any of a wide range of materials including wood, metal, brick, vinyl , and composite materials that can include aluminium, wood, blends of cement and recycled polystyrene ...
Polystyrene is commonly injection molded, vacuum formed, or extruded, while expanded polystyrene is either extruded or molded in a special process. Polystyrene copolymers are also produced; these contain one or more other monomers in addition to styrene.