enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Saddle valve - Wikipedia

   en.wikipedia.org/wiki/Saddle_valve

   A saddle valve used to connect a humidifier's water intake to a residential cold water pipe. A saddle valve is a valve used to supply liquid where a low volume, low pressure stream is required. The name is derived from the fact that it is mounted in such a way that it "saddles" the line, mounting it from both sides.

3. Riser clamp - Wikipedia

   en.wikipedia.org/wiki/Riser_clamp

   A riser clamp is a type of hardware used by mechanical building trades for pipe support in vertical runs of piping (risers) at each floor level. The devices are placed around the pipe, and integral fasteners are then tightened to clamp them onto the pipe.

4. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   These pipe clamps are similar to hose clamps, but are heavier-duty and ideally are made completely of stainless steel (including the screw) to provide maximum service life. [ 21 ] : 149 [ 18 ] : 71 Optionally, the entire rubber sleeve may be jacketed with thin sheet metal, to provide extra stiffness, durability, and resistance to accidental ...

5. Pipe support - Wikipedia

   en.wikipedia.org/wiki/Pipe_support

   A pipe support or pipe hanger is a designed element that transfer the load from a pipe to the supporting structures. The load includes the weight of the pipe proper, the content that the pipe carries, all the pipe fittings attached to pipe, and the pipe covering such as insulation.

6. Diaphragm valve - Wikipedia

   en.wikipedia.org/wiki/Diaphragm_valve

   Diaphragm valves (or membrane valves) consists of a valve body with two or more ports, a flexible diaphragm, and a "weir or saddle" or seat upon which the diaphragm closes the valve. The valve body may be constructed from plastic , metal or other materials depending on the intended use.

7. Electrofusion - Wikipedia

   en.wikipedia.org/wiki/Electrofusion

   Another case was due to a tapping saddle being incorrectly installed on a gas line, causing the death of the two welders in the trench due to gas inhalation. There are many critical parts to electrofusion welding that can cause weld failures, most of which can be greatly reduced by using welding clamps, and correct scraping equipment. [4]