Search results
Results from the WOW.Com Content Network
Cut and fill mining is a method of short-hole mining used in steeply dipping or irregular ore zones, in particular where the hanging wall limits the use of long-hole methods. The ore is mined in horizontal or slightly inclined slices, and then filled with waste rock, sand or tailings. Either fill option may be cemented with binders to add ...
In shrinkage stoping, mining proceeds from the bottom upwards, in horizontal slices (similar to cut and fill mining), with the broken ore being left in place for miners to work from. Because blasted rock takes up a greater volume than in situ rock (due to swell factor ), some of the blasted ore (approximately 40%) must be removed to provide ...
A mass haul diagram where land and rock cuts are hauled to fills Fill construction in 1909 Cut & Fill Software showing cut areas highlighted in red and fill areas shaded in blue. In earthmoving , cut and fill is the process of constructing a railway , road or canal whereby the amount of material from cuts roughly matches the amount of fill ...
The mining method used is underhand cut and fill mining. [ 3 ] The mine's primary access and production are through the Silver Shaft, an 18-foot (5.5 m) diameter, concrete-lined shaft sunk to a depth of 6,200 feet (1,890 m), [ 4 ] [ 5 ] [ 6 ] over 2,800 feet (855 m) below sea level .
Planning for the development of room and pillar mines operates in much the same way as other mining methods, [10] and begins with establishing ownership of the mine. . Following this, the geology of the mine must be analysed, as this will determine factors like the lifespan of the mine, the production requirements, and the cost to develop and
The stope, which is the workshop of the mine, is the excavation from which the ore is extracted. Three methods of stope mining are commonly used. In the "cut and fill" or "open stoping" method, the space remaining following removal of ore after blasting is filled with waste rock and cement.
Surface mining of zinc is typically used for oxide ores, while underground mining yields zinc sulfide ores. [12] Some of the common methods of zinc mining are open pit mining, open stope, and cut and fill mining: [12] [8] [13] [14] Open-pit mining: Surface mining involves the removal of waste rock from above an ore deposit before it can be ...
The mining operation currently consists of two underground mines, Getchell and Turquoise Ridge, operated as the Turquoise Ridge Joint Venture. Barrick Gold is operator and 75% owner with Newmont Mining owning the remaining 25%. [4] The mining methods currently used are cut-and-fill and long hole stoping.