Search results
Results from the WOW.Com Content Network
In shrinkage stoping, mining proceeds from the bottom upwards, in horizontal slices (similar to cut and fill mining), with the broken ore being left in place for miners to work from. Because blasted rock takes up a greater volume than in situ rock (due to swell factor ), some of the blasted ore (approximately 40%) must be removed to provide ...
Cut and fill mining is a method of short-hole mining used in steeply dipping or irregular ore zones, in particular where the hanging wall limits the use of long-hole methods. The ore is mined in horizontal or slightly inclined slices, and then filled with waste rock, sand or tailings. Either fill option may be cemented with binders to add ...
Room and pillar mining was one of the earliest methods used, [3] although with significantly more manpower. The room and pillar system is used in mining coal , gypsum , [ 4 ] iron , [ 5 ] limestone , [ 6 ] and uranium [ 7 ] ores, particularly when found as manto or blanket deposits, stone and aggregates , talc , soda ash , and potash . [ 8 ]
The mining method used is underhand cut and fill mining. [ 3 ] The mine's primary access and production are through the Silver Shaft, an 18-foot (5.5 m) diameter, concrete-lined shaft sunk to a depth of 6,200 feet (1,890 m), [ 4 ] [ 5 ] [ 6 ] over 2,800 feet (855 m) below sea level .
Open-pit mining, also known as open-cast or open-cut mining and in larger contexts mega-mining, [1] is a surface mining technique that extracts rock or minerals from the earth. Open-pit mines are used when deposits of commercially useful ore or rocks are found near the surface where the overburden is relatively thin. In contrast, deeper mineral ...
These benches are typically referred to as either "coastal benches," "wave-cut benches," or "wave-cut platforms." [2] [3] In mining, a bench is a narrow, strip of land cut into the side of an open-pit mine. These step-like zones are created along the walls of an open-pit mine for access and mining. [1]
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
The first step of recovery was to bring the mixture of gold and dirt from the ground to the surface or from a hillside down to a bench. There were two methods: digging a shaft or using pressurized water to either wash soil down a hillside or suck it up from the ground.