Ad
related to: pulse modulation in radar systems for home audiocrutchfield.com has been visited by 100K+ users in the past month
- A/V Cables
Complete Your System with Quality
Cables and Power Protection
- Stereo Receivers
Putting Together an Audio System
Just for Music? We Have You Covered
- Sound Bar Speakers
The Simple and Popular Solution to
Get Better Sound from Your TV
- Home Theater
A/V Gear to Bring the Movie Theater
Experience into Your Living Room
- A/V Cables
Search results
Results from the WOW.Com Content Network
Radar Pulse Train. The carrier is an RF signal, typically of microwave frequencies, which is usually (but not always) modulated to allow the system to capture the required data. In simple ranging radars, the carrier will be pulse modulated and in continuous wave systems, such as Doppler radar, modulation may not be required
Pulse compression is a signal processing technique commonly used by radar, sonar and echography to either increase the range resolution when pulse length is constrained or increase the signal to noise ratio when the peak power and the bandwidth (or equivalently range resolution) of the transmitted signal are constrained.
Doppler signals fall between 1.5 kHz, and 15 kHz, which is audible, so audio signals from medium-PRF radar systems can be used for passive target classification. For example, an L band radar system using a PRF of 10 kHz with a duty cycle of 3.3% can identify true range to a distance of 450 km (30 * C / 10,000 km/s).
The chirp pulse compression process transforms a long duration frequency-coded pulse into a narrow pulse of greatly increased amplitude. It is a technique used in radar and sonar systems because it is a method whereby a narrow pulse with high peak power can be derived from a long duration pulse with low peak power.
A Barker code resembles a discrete version of a continuous chirp, another low-autocorrelation signal used in other pulse compression radars. The positive and negative amplitudes of the pulses forming the Barker codes imply the use of biphase modulation or binary phase-shift keying; that is, the change of phase in the carrier wave is 180 degrees.
Pulse Doppler radar may have 50 or more pulses between the radar and the reflector. Pulse Doppler relies on medium pulse repetition frequency (PRF) from about 3 kHz to 30 kHz. Each transmit pulse is separated by 5 km to 50 km distance. Range and speed of the target are folded by a modulo operation produced by the sampling process.
The first operational pulse-Doppler radar was in the CIM-10 Bomarc, an American long range supersonic missile powered by ramjet engines, and which was armed with a W40 nuclear weapon to destroy entire formations of attacking enemy aircraft. [1] Pulse-Doppler systems were first widely used on fighter aircraft starting in the 1960s. Earlier ...
Monopulse radar is a radar system that uses additional encoding of the radio signal to provide accurate directional information. The name refers to its ability to extract range and direction from a single signal pulse. Monopulse radar avoids problems seen in conical scanning radar systems, which can be confused by rapid changes in signal strength.
Ad
related to: pulse modulation in radar systems for home audiocrutchfield.com has been visited by 100K+ users in the past month