enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Plumbing fixture - Wikipedia

   en.wikipedia.org/wiki/Plumbing_fixture

   Each of these plumbing fixtures has one or more water outlets and a drain. In some cases, the drain has a device that can be manipulated to block the drain to fill the basin of the fixture. Each fixture also has a flood rim, or level at which water will begin to overflow. Most fixtures also have an overflow, which is a conduit for water to ...

3. Clear Out Drains in Showers and Sinks With These Editor ... - AOL

   www.aol.com/best-drain-cleaners-tub-shower...

   An affordable yet durable drain snake is good to have on hand for more serious drain clogs that require a bit of elbow grease, like in your bathtub, or if you have to unclog very frequently and ...

4. Plug (sanitation) - Wikipedia

   en.wikipedia.org/wiki/Plug_(sanitation)

   Plug for a sink. A plug in sanitation is an object that is used to close a drainage outlet firmly. The insertion of a plug into a drainage outlet allows the container to be filled with water or other fluids. In contrast to screw on caps, plugs are pushed into the hole and are not put over the hole.

5. Drain (plumbing) - Wikipedia

   en.wikipedia.org/wiki/Drain_(plumbing)

   A drain cover is a cover with holes (e.g. a manhole) or a grating used to cover a drain, to prevent unwanted entry of foreign objects, or injury to people or animals. It allows drainage of liquids but prevents entry from large solid objects, and thus acts as a coarse filter. A sink drain cover is a drain cover used to cover the sink drain.

6. AOL

   search.aol.com

   The search engine that helps you find exactly what you're looking for. Find the most relevant information, video, images, and answers from all across the Web.

7. Sink - Wikipedia

   en.wikipedia.org/wiki/Sink

   A bottom mount sink at the Ernest Hemingway House. Bottom-mount or under-mount sinks are installed below the countertop surface. The edge of the countertop material is exposed at the hole created for the sink (and so must be a carefully finished edge rather than a rough cut). The sink is then clamped to the bottom of the material from below.