Search results
Results from the WOW.Com Content Network
Calculation of the steam turbine shaft radius for a turboset: Assumptions: Power carried by the shaft is 1000 MW; this is typical for a large nuclear power plant. Yield stress of the steel used to make the shaft (τ yield) is: 250 × 10 6 N/m 2. Electricity has a frequency of 50 Hz; this is the typical frequency in Europe. In North America, the ...
For example, if a person places a force of 10 N at the terminal end of a wrench that is 0.5 m long (or a force of 10 N acting 0.5 m from the twist point of a wrench of any length), the torque will be 5 N⋅m – assuming that the person moves the wrench by applying force in the plane of movement and perpendicular to the wrench.
The whirling frequency of a symmetric cross section of a given length between two points is given by: N = 94.251 E I m L 3 RPM {\displaystyle N=94.251{\sqrt {EI \over mL^{3}}}\ {\text{RPM}}} where: E = Young's modulus, I = second moment of area , m = mass of the shaft, L = length of the shaft between points.
Non-circular cross-sections always have warping deformations that require numerical methods to allow for the exact calculation of the torsion constant. [ 2 ] The torsional stiffness of beams with non-circular cross sections is significantly increased if the warping of the end sections is restrained by, for example, stiff end blocks.
For rod length 6" and crank radius 2" (as shown in the example graph below), numerically solving the acceleration zero-crossings finds the velocity maxima/minima to be at crank angles of ±73.17615°. Then, using the triangle law of sines, it is found that the rod-vertical angle is 18.60647° and the crank-rod angle is 88.21738°. Clearly, in ...
Calculation of the steam turbine shaft radius for a turboset: Assumptions: Power carried by the shaft is 1000 MW; this is typical for a large nuclear power plant. Yield stress of the steel used to make the shaft (τ yield) is: 250 × 10 6 N/m 2. Electricity has a frequency of 50 Hz; this is the typical frequency in Europe.
The torque is then related to the lever length, shaft diameter and measured force. The device is generally used over a range of engine speeds to obtain power and torque curves for the engine, since there is a non-linear relationship between torque and engine speed for most engine types. Power output in SI units may be calculated as follows:
The torque on shaft is 0.0053 N⋅m at 2 A because of the assumed radius of the rotor (exactly 1 m). Assuming a different radius would change the linear K v {\displaystyle K_{\text{v}}} but would not change the final torque result.