enow.com Web Search

  1. Ads

    related to: ejector kits for well pump covers decorative drain lines replacement

Search results

  1. Results from the WOW.Com Content Network
  2. Drain-waste-vent system - Wikipedia

    en.wikipedia.org/wiki/Drain-waste-vent_system

    A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.

  3. Trench drain - Wikipedia

    en.wikipedia.org/wiki/Trench_drain

    Employing a solid cover or grating that is flush with the surrounding surface, this drain is commonly made of concrete in-situ and with the option of using polymer- or metal-based liners or a channel former to aid in channel crafting and slope formation. The drain is characterized by its long length and narrow width, the cross-section of the ...

  4. Sewerage - Wikipedia

    en.wikipedia.org/wiki/Sewerage

    The main interest of dry shotcrete is the capacity to pump the mortar over a long distance and this is needed when the access points are distant. Perhaps the longest dry shotcrete distance is a job site in Australia in 2014, where 100% calcium aluminate mortar was air transported over 800 meters before being sprayed. The main drawback with dry ...

  5. Pumping station - Wikipedia

    en.wikipedia.org/wiki/Pumping_station

    Submersible pumps are mounted on two vertical guide rails and seal onto a permanently fixed "duckfoot", which forms both a mount and also a vertical bend for the discharge pipe. For maintenance or replacement, submersible pumps are raised by a chain off of the duckfoot and up the two guide rails to the maintenance (normally ground) level.

  6. Injector - Wikipedia

    en.wikipedia.org/wiki/Injector

    The S type pump is useful for removing water from a well or container. Shallow well pumps are those in which the jet assembly is attached directly to the main pump and are limited to a depth of approximately 5-8m to prevent cavitation. Deep well pumps are those in which the jet is located at the bottom of the well. The maximum depth for deep ...

  7. Well drainage - Wikipedia

    en.wikipedia.org/wiki/Well_drainage

    Geometry of a fully penetrating well drainage system in a uniform, isotropic aquifer Geometry of a partially penetrating well drainage system in an anisotropic layered aquifer The basic, steady state , equation for flow to fully penetrating wells (i.e. wells reaching the impermeable base) in a regularly spaced well field in a uniform unconfined ...

  1. Ads

    related to: ejector kits for well pump covers decorative drain lines replacement