enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Polyethylene - Wikipedia

   en.wikipedia.org/wiki/Polyethylene

   Polyethylene absorbs almost no water; the gas and water vapour permeability (only polar gases) is lower than for most plastics. Oxygen, carbon dioxide and flavorings, on the other hand, can pass it easily. Polyethylene burns slowly with a blue flame having a yellow tip and gives off an odour of paraffin (similar to candle flame). The material ...

3. High-density polyethylene - Wikipedia

   en.wikipedia.org/wiki/High-density_polyethylene

   HDPE is known for its high strength-to-density ratio. [4] The density of HDPE ranges from 930 to 970 kg/m 3. [5] Although the density of HDPE is only marginally higher than that of low-density polyethylene, HDPE has little branching, giving it stronger intermolecular forces and tensile strength (38 MPa versus 21 MPa) than LDPE. [6]

4. Low-density polyethylene - Wikipedia

   en.wikipedia.org/wiki/Low-density_polyethylene

   LDPE has SPI resin ID code 4 Schematic of LDPE branching structure. Low-density polyethylene (LDPE) is a thermoplastic made from the monomer ethylene.It was the first grade of polyethylene, produced in 1933 by John C. Swallow and M.W Perrin who were working for Imperial Chemical Industries (ICI) using a high pressure process via free radical polymerization. [1]

5. Food contact materials - Wikipedia

   en.wikipedia.org/wiki/Food_contact_materials

   The symbol indicates that the material used in the product is considered safe for food contact. This includes food and water containers, packaging materials, cutlery etc. [3] The regulation is applicable to any product intended for food contact whether it be made of metals, ceramics, paper and board, and plastics or the coating. [4]

6. Recycling codes - Wikipedia

   en.wikipedia.org/wiki/Recycling_codes

   Recycling codes on products. Recycling codes are used to identify the materials out of which the item is made, to facilitate easier recycling process.The presence on an item of a recycling code, a chasing arrows logo, or a resin code, is not an automatic indicator that a material is recyclable; it is an explanation of what the item is made of.

7. Ethylene-vinyl acetate - Wikipedia

   en.wikipedia.org/wiki/Ethylene-vinyl_acetate

   The EVA copolymer which is based on a low proportion of VA (approximately up to 4%) may be referred to as vinyl acetate modified polyethylene. It is a copolymer and is processed as a thermoplastic material – just like low-density polyethylene. It has some of the properties of a low-density polyethylene but increased gloss (useful for film ...

8. Materials for use in vacuum - Wikipedia

   en.wikipedia.org/wiki/Materials_for_use_in_vacuum

   Many plastics, namely many plastic tapes (special attention should be paid to adhesives). Fiberglass composites, e.g. Micarta (G-10) and G-30, should be avoided. Even Kapton and Teflon are sometimes advised against. See below for further discussion of plastics. [3] PVC, usually in the form of wire insulation (also a source of leaks)

9. Polyethylene terephthalate - Wikipedia

   en.wikipedia.org/wiki/Polyethylene_terephthalate

   Polyethylene terephthalate is produced largely from purified terephthalic acid (PTA), as well as to a lesser extent from (mono-)ethylene glycol (MEG) and dimethyl terephthalate (DMT). [ 41 ] [ 5 ] As of 2022, ethylene glycol is made from ethene found in natural gas , while terephthalic acid comes from p-xylene made from crude oil .