enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. IEC 60309 - Wikipedia

   en.wikipedia.org/wiki/IEC_60309

   The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.

3. IEC 60320 - Wikipedia

   en.wikipedia.org/wiki/IEC_60320

   A variety of different kinds of IEC 60320 plugs and sockets. IEC 60320 Appliance couplers for household and similar general purposes [1] is a set of standards from the International Electrotechnical Commission (IEC) specifying non-locking connectors for connecting power supply cords to electrical appliances of voltage not exceeding 250 V (a.c.) and rated current not exceeding 16 A. [1 ...

4. AC power plugs and sockets: British and related types

   en.wikipedia.org/wiki/AC_power_plugs_and_sockets:...

   By the 1927 revision of BS 73 four sizes of two-pin plugs and sockets were standardized: 2 A, 5 A, 15 A and 30 A. This was later superseded by BS 372:1930 part 1 Two-pin Side-entry Wall Plugs And Sockets for Domestic Purposes. Following the introduction of BS 4573 in 1970 there were no longer any UK domestic uses for two-pin sockets except for ...

5. Industrial and multiphase power plugs and sockets - Wikipedia

   en.wikipedia.org/wiki/Industrial_and_multiphase...

   Semko 17 were 3/4-pin 3-phase connectors, with (4-pin) or without (3-pin) a neutral connector. Earth were provided via the shield. The connectors were available in different sizes, 16 A with rounded corners; 25 A and 63 A were rectangular. These connectors were used mainly in industrial and agricultural installations.

6. SAE J1772 - Wikipedia

   en.wikipedia.org/wiki/SAE_J1772

   A competing proposal known as the Mennekes connector initiated by RWE and Daimler was standardized in 2011's IEC 62196 as its Type 2 connector. It has been widely adopted as the European Union's standard single- and three-phase coupler. [12] [36] The connector adopted the same protocols for the pilot pin as J1772's J-Plug. The IEC specification ...

7. NEMA enclosure types - Wikipedia

   en.wikipedia.org/wiki/NEMA_enclosure_types

   2: Drip-tight. Similar to Type 1 but with addition of drip shields; used where condensation may be severe (as in cooling and laundry rooms). 3: Weather-resistant. Protects against falling dirt and windblown dust, against weather hazards such as rain, sleet and snow, and is undamaged by the formation of ice.