enow.com Web Search

  1. Ads

    related to: thermostat livestock water tank heater leaking drain cap with hose attachment

Search results

  1. Results from the WOW.Com Content Network
  2. Here's How Often You Should Drain Your Water Heater ... - AOL

    www.aol.com/lifestyle/heres-often-drain-water...

    Step 5: Once the tank is empty, turn the cold-water supply on to flush the tank with clean water until it runs clear from the drain valve. Step 6: Remove the hose and close your drain valve before ...

  3. Heat trap - Wikipedia

    en.wikipedia.org/wiki/Heat_trap

    Microcirculation on the left: Heated water is rising into the pipe on top of the hot water tank, cooling off on the sides of the pipe and thence circulating back into the tank. Right: Circulation of hot water is inhibited by the loop in the pipe. Heat traps are valves or loops of pipe on the cold water inlet and hot water outlet of water heaters.

  4. Thermostatic mixing valve - Wikipedia

    en.wikipedia.org/wiki/Thermostatic_mixing_valve

    The storage of water at high temperature removes one possible breeding ground for Legionella; the use of a thermostat, rather than a static mixing valve, provides increased safety against scalding, and increased user comfort, because the hot-water temperature remains constant. [1] Many TMVs use a wax thermostat for regulation. They also shut ...

  5. Water heat recycling - Wikipedia

    en.wikipedia.org/wiki/Water_heat_recycling

    Installation of a double-walled copper-on-copper heat exchanger in a vertical section of the master drain line in a Canadian home (2007) Water heat recycling (also known as drain water heat recovery, waste water heat recovery, greywater heat recovery, [citation needed] or sometimes shower water heat recovery [citation needed]) is the use of a heat exchanger to recover energy and reuse heat ...

  6. Piping and plumbing fitting - Wikipedia

    en.wikipedia.org/wiki/Piping_and_plumbing_fitting

    A trap primer automatically injects water into a trap, maintaining a water seal to keep sewer gas out of buildings. It must be installed in an easily accessible place for adjustment, replacement, and repair. A trap primer, a specialized valve, is usually connected to a clean-water supply in addition to a DWV system. [21]

  7. Trap (plumbing) - Wikipedia

    en.wikipedia.org/wiki/Trap_(plumbing)

    Maintaining the water seal is critical to trap operation; traps might dry out, and poor venting can suction or blow water out of the traps. This is usually avoided by venting the drain pipes downstream of the trap; by being vented to the atmosphere outside the building, the drain lines never operate at a pressure much higher or lower than ...

  1. Ads

    related to: thermostat livestock water tank heater leaking drain cap with hose attachment