enow.com Web Search

  1. Ads

    related to: bathroom sink water supply lines height requirements size chart images printable

Search results

  1. Results from the WOW.Com Content Network
  2. Uniform Plumbing Code - Wikipedia

    en.wikipedia.org/wiki/Uniform_Plumbing_Code

    New alternate water sources for nonpotable applications and nonpotable rainwater catchment systems (Chapters 16, 17) based upon IAPMO’s Green Plumbing and Mechanical Code Supplement New Appendix L (sustainable practices) New minimum plumbing facilities table (Chapter 4) Water supply and drainage joint connection requirements (Chapters 6, 7) [12]

  3. Air gap (plumbing) - Wikipedia

    en.wikipedia.org/wiki/Air_gap_(plumbing)

    Water cannot flow from the sink to the tap in normal circumstances, even if the water supply loses pressure. An air gap , as related to the plumbing trade, is the unobstructed vertical space between the water outlet and the flood level of a fixture . [ 1 ]

  4. Fixture unit - Wikipedia

    en.wikipedia.org/wiki/Fixture_unit

    A fixture unit is equal to 1 cubic foot (0.028 m 3) of water drained in a 1 + 1 ⁄ 4 inches (32 mm) diameter pipe over one minute. [2] One cubic foot of water is roughly 7.48 US gallons (28.3 L; 6.23 imp gal). A Fixture Unit is used in plumbing design for both water supply and waste water. Different fixtures have different flow requirements.

  5. Plumbing fixture - Wikipedia

    en.wikipedia.org/wiki/Plumbing_fixture

    Each fixture usually has a characteristic means of connection. Normal plumbing practice is to install a valve on each water supply line before the fixture, and this is most commonly termed a stop or "service valve". The water supply to some fixtures is cold water only (such as water closets and urinals). Most fixtures also have a hot water supply.

  6. Piping and plumbing fitting - Wikipedia

    en.wikipedia.org/wiki/Piping_and_plumbing_fitting

    A reducer reduces the pipe size from a larger to a smaller bore (inner diameter). Alternatively, reducer may refer to any fitting which causes a change in pipe diameter. [15] This change may be intended to meet hydraulic flow requirements of the system or adapt to existing piping of a different size. The reduction length is usually equal to the ...

  7. Drain-waste-vent system - Wikipedia

    en.wikipedia.org/wiki/Drain-waste-vent_system

    The key to a functional island fixture vent is that the top elbow must be at least as high as the "flood level" (the peak possible drain water level in the sink), allowing it to serve as a de facto vacuum breaker preventing the loop from becoming a siphon for an overfilled sink, as from a clogged drain (rather than vent) line.

  1. Ads

    related to: bathroom sink water supply lines height requirements size chart images printable