Search results
Results from the WOW.Com Content Network
The hydraulic braking system is designed as a closed system: unless there is a leak in the system, none of the brake fluid enters or leaves it, nor does the fluid get consumed through use. Leakage may happen, however, from cracks in the O-rings or from a puncture in the brake line.
The purpose is to reduce failures in hydraulic braking systems of motor vehicles which may occur because of the manufacture or use of improper or contaminated fluid. The standard applies to all fluid use of passenger cars, multipurpose passenger vehicles, trucks, buses, trailers and motorcycles equipped with a hydraulic brake system. [1]
Sensotronic Brake Control (SBC) is an electro-hydraulic brake system developed by Daimler and Bosch. In this system, the wheel brake cylinders of a vehicle are operated through a servomechanism, offering precise and responsive braking. The SBC system was first introduced on the R230 SL-class, which was released in Europe in October 2001. [1]
The most common vehicle uses of master cylinders are in brake and clutch systems.. In brake systems, the operated devices are cylinders inside brake calipers and/or drum brakes; these cylinders may be called wheel cylinders or slave cylinders, and they push the brake pads towards a surface that rotates with the wheel (this surface is typically either a drum or a disc, a.k.a. a rotor) until the ...
Since the ideal brake system would use only hard tubing for its lack of expansion, but some use of flexible hose is required, the ideal compromise is to use a hose type that allows a minimal rate of expansion. Thus the assertion that braided stainless steel hose is superior as compared to a typical rubber hose when used in a hydraulic brake system.
A power braking system consists of several distinct components, including the vacuum booster, master cylinder, brake fluid reservoir and lines, and calipers (or drums). Power brakes have been around in some form since the 1920s, and since the late 20th century all cars sold in North America have been equipped with power brakes.
The HLA system is called a parallel hydraulic hybrid. In parallel systems the original vehicle drive-line remains, allowing the vehicle to operate normally when the HLA system is disengaged. When the HLA is engaged, energy is captured during deceleration and released during acceleration, in contrast to series hydraulic hybrid systems which ...
A wheel cylinder is a component of a hydraulic drum brake system. [1] It is located in each wheel and is usually positioned at the top of the wheel, above the shoes. Its function is to exert force onto the shoes so as to bring them into contact with the drum and stop the vehicle with friction. [2]