enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Lug nut - Wikipedia

   en.wikipedia.org/wiki/Lug_nut

   The conical lug's taper is normally 60 degrees (although 45 degrees is common for wheels designed for racing applications), and is designed to help center the wheel accurately on the axle, and to reduce the tendency for the nut to loosen due to fretting induced precession, as the car is driven. One popular alternative to the conical lug seating ...

3. Screw thread - Wikipedia

   en.wikipedia.org/wiki/Screw_thread

   The left grinding wheel on a bench grinder; The axle nuts, or less commonly, lug nuts on the left side of some automobiles; The securing nut on some circular saw blades – the large torque at startup should tend to tighten the nut; The spindle on brushcutter and line trimmer heads, so that the torque tends to tighten rather than loosen the ...

4. Wheel stud - Wikipedia

   en.wikipedia.org/wiki/Wheel_stud

   Wheel hub with disc brake and 5 wheel studs. Wheel studs are the threaded fasteners that hold on the wheels of many automobiles. They are semi-permanently mounted directly to the vehicle hub, usually through the brake drum or brake disk. Lug nuts are fastened onto the wheel stud to secure the wheel. When a wheel is removed for tire changes etc ...

5. Wheel sizing - Wikipedia

   en.wikipedia.org/wiki/Wheel_sizing

   The design of tuner lug nuts can range from bit style to multisided or spline drive, and are sometimes lightweight for performance purposes. Another variation of lug nut is the "locking wheel nut", which is used as a theft prevention method to keep thieves from stealing a vehicle's wheels. When utilizing locking wheel nuts, one standard lug nut ...

6. Centerlock wheel - Wikipedia

   en.wikipedia.org/wiki/Centerlock_wheel

   These consist of a shaft at the hub, with an external screw thread, a straight external spline section and a tapered interface at the hub base. The wheel centers have internal splines and a matching taper to align and center them on the hub. The wheels are fastened to the hub by means of a winged, threaded nut, called a "knock-off" or "spinner."

7. Unified Thread Standard - Wikipedia

   en.wikipedia.org/wiki/Unified_Thread_Standard

   The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than ⁠ 1 / 4 ⁠ inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.