Ads
related to: making circuit boards at home- Custom Design Process
Custom Design for Enclosures,
Panels, Housings & Other Parts
- Request a Custom Quote
Describe Details of Your Project.
Our Experts Will Help You Out.
- Custom Plastic Enclosures
Cost-Effective and Rapid Production
No Molds. No Tooling.
- No Molds Required
Learn More About Our Unique
Plastic Fabrication Technology
- Custom Design Process
discoverpanel.com has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
Dip soldering is a small-scale soldering process by which electronic components are soldered to a printed circuit board (PCB) to form an electronic assembly. The solder wets to the exposed metallic areas of the board (those not protected with solder mask ), creating a reliable mechanical and electrical connection.
Wave soldering uses surface tension to keep solder from bridging the insulating gaps between the copper lines of flux-coated printed wiring boards/printed circuit boards. The electric soldering iron is widely used for hand-soldering, consisting of a heating element in contact with the "iron" (a larger mass of metal, usually copper) which is in ...
As an alternative, many circuit board assembly houses coat assemblies with a layer of transparent conformal coating rather than potting. [5] Conformal coating gives most of the benefits of potting, and is lighter and easier to inspect, test, and repair. Conformal coatings can be applied as liquid or condensed from a vapor phase.
Through-hole devices mounted on the circuit board of a mid-1980s home computer.Axial-lead devices are at upper left, while blue radial-lead capacitors are at upper right Close-up view of an electronic circuit board showing component lead holes (gold-plated) with through-hole plating up the sides of the hole to connect tracks on both sides of the board.
Wire wrap construction became popular around 1960 in circuit board manufacturing, and use has now sharply declined. Surface-mount technology has made the technique much less useful than in previous decades. Solder-less breadboards and the decreasing cost of professionally made PCBs have nearly eliminated this technology.
Section of a typical Australian late 1930s radio, showing the point to point construction between components. In electronics, point-to-point construction is a non-automated technique for constructing circuits which was widely used before the use of printed circuit boards (PCBs) and automated assembly gradually became widespread following their introduction in the 1950s.
Ads
related to: making circuit boards at homediscoverpanel.com has been visited by 10K+ users in the past month