enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Chevrolet C/K (fourth generation) - Wikipedia

   en.wikipedia.org/wiki/Chevrolet_C/K_(fourth...

   In August 1998, General Motors released the GMT800 generation of full-size pickups for the 1999 model year as the replacement for the fourth-generation C/K trucks introduced for 1988. The long-running C/K nomenclature was retired by Chevrolet in favor of a singular Chevrolet Silverado nameplate (as GMC had done in 1988 with the GMC Sierra).

3. Overrun brake - Wikipedia

   en.wikipedia.org/wiki/Overrun_brake

   An overrun brake (called a surge brake when invented) is a brake system commonly used on small trailers, where the motion of the trailer with respect to the towing vehicle is used to actuate the brake. The early systems were fitted with a spring system which was not very effective.

4. Master cylinder - Wikipedia

   en.wikipedia.org/wiki/Master_cylinder

   The most common vehicle uses of master cylinders are in brake and clutch systems.. In brake systems, the operated devices are cylinders inside brake calipers and/or drum brakes; these cylinders may be called wheel cylinders or slave cylinders, and they push the brake pads towards a surface that rotates with the wheel (this surface is typically either a drum or a disc, a.k.a. a rotor) until the ...

5. Chevrolet C/K - Wikipedia

   en.wikipedia.org/wiki/Chevrolet_C/K

   A four-cylinder diesel (Perkins 4236 3.8L) was introduced for 1978 in the D10 pickup. [4] For 1981, the engine line was reduced to two, with a 4.1L inline-six becoming offered in gasoline and ethanol-fuel versions (C-10 and A-10) and the Perkins 4236 (D10).

6. Brake bleeding - Wikipedia

   en.wikipedia.org/wiki/Brake_bleeding

   The process is performed by forcing clean, bubble-free brake fluid through the entire system, usually from the master cylinder(s) to the calipers of disc brakes (or the wheel cylinders of drum brakes), but in certain cases in the opposite direction. A brake bleed screw is normally mounted at the highest point on each cylinder or caliper.

7. Brake pad - Wikipedia

   en.wikipedia.org/wiki/Brake_pad

   Worn brake pads, contaminated brake fluid, faulty brake caliper, faulty master cylinder, loss of vacuum, loss of brake fluid Car pulls to one side when braking Faulty brake caliper, restriction in hydraulic system, brake pad lining(s) contaminated with oil or brake fluid, brake pads not replaced in pairs, brake pad not fitted correctly,