Search results
Results from the WOW.Com Content Network
File-backed mapping maps an area of the process's virtual memory to files; that is, reading those areas of memory causes the file to be read. It is the default mapping type. Anonymous mapping maps an area of the process's virtual memory not backed by any file, made available via the MAP_ANONYMOUS/MAP_ANON flags.
A memory-mapped file is a segment of virtual memory [1] that has been assigned a direct byte-for-byte correlation with some portion of a file or file-like resource. This resource is typically a file that is physically present on disk, but can also be a device, shared memory object, or other resource that an operating system can reference through a file descriptor.
Memory-mapped I/O is preferred in IA-32 and x86-64 based architectures because the instructions that perform port-based I/O are limited to one register: EAX, AX, and AL are the only registers that data can be moved into or out of, and either a byte-sized immediate value in the instruction or a value in register DX determines which port is the source or destination port of the transfer.
Memory-mapped file, also known as mmap() Memory-mapped I/O, an alternative to port I/O; a communication between CPU and peripheral device using the same instructions, and same bus, as between CPU and memory; Virtual memory, technique which gives an application program the impression that it has contiguous working memory, while in fact it is ...
In contrast, in direct memory access (DMA) operations, the CPU is uninvolved in the data transfer. The term can refer to either memory-mapped I/O (MMIO) or port-mapped I/O (PMIO). PMIO refers to transfers using a special address space outside of normal memory, usually accessed with dedicated instructions, such as IN and OUT in x86 architectures.
When reading from standard program storage, there are no side-effects due to the order of memory read operations. In embedded system programming, it is very common to have memory-mapped I/O where reads and writes to memory trigger I/O operations, or changes to the processor's operational mode, which are highly visible side effects. For the ...
A GPIO pin's state may be exposed to the software developer through one of a number of different interfaces, such as a memory-mapped I/O peripheral, or through dedicated IO port instructions. Some GPIOs have 5 V tolerant inputs: even when the device has a low supply voltage (such as 2 V), the device can accept 5 V without damage.
In computer programming, a value is said to be volatile if it can be read or modified asynchronously by something other than the current thread of execution.The value of a volatile variable may spontaneously change for reasons such as: sharing values with other threads; sharing values with asynchronous signal handlers; accessing hardware devices via memory-mapped I/O (where you can send and ...