enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Ridgid - Wikipedia

   en.wikipedia.org/wiki/Ridgid

   Ridgid tools are targeted at the plumbing, pipe fitting, construction, and HVAC trades. The brand is best known for its distinctive red pipe wrenches, [2] [3] but the company manufactures over 300 different types of tools. [1] The company also sells power tools, largely made by TTI, and wet/dry vacs, made by parent company Emerson. [4]

3. Punch (tool) - Wikipedia

   en.wikipedia.org/wiki/Punch_(tool)

   A center punch forms a large enough dimple to "guide" the tip of the drill. The tip of a center punch has an angle between 60 and 90 degrees. [1] When drilling larger holes, where the drill bit is wider than the indentation produced by a center punch, the drilling of a pilot hole is usually needed. An automatic center punch operates without the ...

4. Screw extractor - Wikipedia

   en.wikipedia.org/wiki/Screw_extractor

   The screw is drilled out with the appropriate drill and drill bushing. The extractor is then hammered into the hole with a brass hammer, because a steel hammer is more likely to cause the extractor to break. The appropriate special nut is then attached to the end of the extractor. The nuts can then be turned with a wrench to remove the screw. [1]

5. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   A bit used to enlarge an existing hole is called a core drill bit. The existing hole may be the result of a core from a casting or a stamped (punched) hole. The name comes from its first use, for drilling out the hole left by a foundry core, a cylinder placed in a mould for a casting that leaves an irregular hole in the product. This core drill ...

6. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   Nominal (thread) sizes range from 0.1875 to 0.375 in (4.763 to 9.525 mm) and lengths from 1.25 to 5 in (32 to 127 mm). Typically an installer uses a hammer drill to make a pilot hole for each concrete screw and a powered impact driver to drive the screw. The drill hole should be 1/2" longer than the depth penetration of the screw.

7. 17 Hilarious Comics That Show What Happens When Modern Life ...

   www.aol.com/medieval-humor-modern-problems-17...

   Ilya Stallone takes the quirky charm of medieval art and mashes it up with the chaos of modern life, creating comics that feel both hilarious and oddly timeless. Using a style straight out of ...