Search results
Results from the WOW.Com Content Network
This page contains tables of azeotrope data for various binary and ternary mixtures of solvents. The data include the composition of a mixture by weight (in binary azeotropes, when only one fraction is given, it is the fraction of the second component), the boiling point (b.p.) of a component, the boiling point of a mixture, and the specific gravity of the mixture.
The oleum is then diluted with water to form concentrated sulfuric acid. H 2 SO 4 + SO 3 → H 2 S 2 O 7 H 2 S 2 O 7 + H 2 O → 2 H 2 SO 4. Directly dissolving SO 3 in water, called the "wet sulfuric acid process", is rarely practiced because the reaction is extremely exothermic, resulting in a hot aerosol of sulfuric acid that requires ...
The solvent (e.g. water) is omitted from this expression when its concentration is effectively unchanged by the process of acid dissociation. The strength of a weak acid can be quantified in terms of a dissociation constant , K a {\displaystyle K_{a}} , defined as follows, where [ H ] {\displaystyle {\ce {[H]}}} signifies the concentration of a ...
An example of a negative azeotrope is hydrochloric acid at a concentration of 20.2% and 79.8% water (by mass). Hydrogen chloride boils at −85 °C and water at 100 °C, but the azeotrope boils at 110 °C, which is higher than either of its constituents. The maximum boiling point of any hydrochloric acid solution is 110 °C. Other examples:
The tables below provides information on the variation of solubility of different substances (mostly inorganic compounds) in water with temperature, at one atmosphere pressure. Units of solubility are given in grams of substance per 100 millilitres of water (g/(100 mL)), unless shown otherwise. The substances are listed in alphabetical order.
In practice, the mixture can be created by dissolving the acid in water, and adding the requisite amount of strong acid or base. When the pK a and analytical concentration of the acid are known, the extent of dissociation and pH of a solution of a monoprotic acid can be easily calculated using an ICE table.
Sulfur water is made out of dissolved minerals that contain sulfate. These include baryte (BaSO 4), epsomite (MgSO 4 7H 2 O) and gypsum (CaSO 4 2H 2 0). [1] It is reported that a notable change in taste to the water is found dependent upon the type of sulfate affecting the water.
Normality can be used for acid-base titrations. For example, sulfuric acid (H 2 SO 4) is a diprotic acid. Since only 0.5 mol of H 2 SO 4 are needed to neutralize 1 mol of OH −, the equivalence factor is: f eq (H 2 SO 4) = 0.5. If the concentration of a sulfuric acid solution is c(H 2 SO 4) = 1 mol/L, then its normality is 2 N. It can also be ...