Search results
Results from the WOW.Com Content Network
The grooved trolley wheel was used on many large city systems through the 1940s and 1950s; it was generally used on systems with "old" style round cross sectional overhead wire. The trolley wheel was problematic at best; the circumferential contact of the grooved wheel bearing on the underside of the overhead wire provided minimal electrical ...
Busscar trolleybus in São Paulo, Brazil Solaris trolleybus in Landskrona, Sweden Video of a trolleybus in Ghent, Belgium. A trolleybus (also known as trolley bus, trolley coach, trackless trolley, trackless tram – in the 1910s and 1920s [1] – or trolley [2] [3]) is an electric bus that draws power from dual overhead wires (generally suspended from roadside posts) using spring-loaded ...
The first trolleybus line was opened by the former Market Street Railway Company (MSR). The San Francisco Municipal Railway ("Muni") opened the second trolleybus line on 7 September 1941. MSR was absorbed by Muni on 29 September 1944. Most of the current trolleybus system was built to replace MSR tramway lines.
Boston Neoplan DMA-460LF dual-mode trolleybus, operating in diesel mode (with its trolley poles lowered). A dual-mode bus is a bus that can run independently on power from two different sources, typically electricity from overhead lines like a trolleybus or from batteries like a hybrid bus, alternated with conventional fossil fuel (generally diesel fuel).
Trolley pole wheel on top of the trolley pole of Twin City Rapid Transit Company No. 1300. A current collector (often called a "pickup") is a device used in trolleybuses, trams, electric locomotives and EMUs to carry electric power from overhead lines, electric third rails, or ground-level power supplies to the electrical equipment of the vehicles.
Much like trams, GLT vehicles can dock with low station platforms for level boarding. While the GLT's central guidance rail is not significantly less expensive than the rails needed by regular trams, the overall system can be installed at a lower cost since existing trolleybus wires can be used without the installation of tracks, and not all new sections need rails or electric wires installed ...
The search engine that helps you find exactly what you're looking for. Find the most relevant information, video, images, and answers from all across the Web.
Trams draw their power from a single overhead wire at about 500 to 750 V DC. Trolleybuses draw from two overhead wires at a similar voltage, and at least one of the trolleybus wires must be insulated from tram wires. This is usually done by the trolleybus wires running continuously through the crossing, with the tram conductors a few ...