enow.com Web Search

  1. Ads

    related to: rtd sensor vs thermocouple light control box controller relay location

Search results

  1. Results from the WOW.Com Content Network
  2. Resistance thermometer - Wikipedia

    en.wikipedia.org/wiki/Resistance_thermometer

    Resistance thermometers, also called resistance temperature detectors (RTDs), are sensors used to measure temperature. Many RTD elements consist of a length of fine wire wrapped around a heat-resistant ceramic or glass core but other constructions are also used. The RTD wire is a pure material, typically platinum (Pt), nickel (Ni), or copper ...

  3. List of temperature sensors - Wikipedia

    en.wikipedia.org/wiki/List_of_temperature_sensors

    The integrated circuit sensor may come in a variety of interfaces — analogue or digital; for digital, these could be Serial Peripheral Interface, SMBus/I 2 C or 1-Wire.. In OpenBSD, many of the I 2 C temperature sensors from the below list have been supported and are accessible through the generalised hardware sensors framework [3] since OpenBSD 3.9 (2006), [4] [5]: §6.1 which has also ...

  4. Relay logic - Wikipedia

    en.wikipedia.org/wiki/Relay_logic

    In many cases, it is possible to design a relay logic diagram directly from the narrative description of a control event sequence. In general, the following suggestions apply to designing a relay logic diagram: 1. Define the process to be controlled. 2. Draw a sketch of the operation process. Make sure all the components of the system are ...

  5. Photoelectric sensor - Wikipedia

    en.wikipedia.org/wiki/Photoelectric_sensor

    Remote photoelectric sensors used for remote sensing contain only the optical components of a sensor. The circuitry for power input, amplification, and output switching is located elsewhere, typically in a control panel. This allows the sensor, itself, to be very small. Also, the controls for the sensor are more accessible, since they may be ...

  6. HVAC control system - Wikipedia

    en.wikipedia.org/wiki/HVAC_control_system

    The unit controllers typically have analog and digital inputs that allow measurement of the variable (temperature, humidity, or pressure) and analog and digital outputs for control of the transport medium (hot/cold water and/or steam). Digital inputs are typically (dry) contacts from a control device, and analog inputs are typically a voltage ...

  7. ANSI device numbers - Wikipedia

    en.wikipedia.org/wiki/ANSI_device_numbers

    81R - common industry use for Rate Of Change Of Frequency Relay (ROCOF) 81U - Under Frequency; 82 - DC Reclosing Relay; 83 - Automatic Selective Control or Transfer Relay; 84 - Operating Mechanism; 85 - Pilot Communications, Carrier or Pilot-Wire Relay; 86 - Lock-Out Relay, Master Trip Relay; 87 - Differential Protective Relay; 87B - Bus ...

  8. Thermocouple - Wikipedia

    en.wikipedia.org/wiki/Thermocouple

    A thermocouple, also known as a "thermoelectrical thermometer", is an electrical device consisting of two dissimilar electrical conductors forming an electrical junction.A thermocouple produces a temperature-dependent voltage as a result of the Seebeck effect, and this voltage can be interpreted to measure temperature.

  9. Thermopile - Wikipedia

    en.wikipedia.org/wiki/Thermopile

    The two top thermocouple junctions are at temperature T 1 while the two bottom thermocouple junctions are at temperature T 2. The output voltage from the thermopile, ΔV , is directly proportional to the temperature differential, ΔT or T 1 - T 2 , across the thermal resistance layer and number of thermocouple junction pairs.

  1. Ads

    related to: rtd sensor vs thermocouple light control box controller relay location